User's Manual

Chapter 5: Base Station Configuration
RRM Groups
122
Teklogix 9150 Wireless Gateway User Manual
Communication Protocol
This listbox allows you to select the protocol to be used for the connection to this
RRM group. The default is the TCP/IP protocol.
Enabled
The Enabled option must be turned on ( √ ) for the 9150 to function as an RRM
group controller. If this option is disabled, the 9150 automatically goes into base
station mode.
Auto-Startup
When this parameter is enabled ( √ ), the 9150 establishes communication with the
RRMs in this RRM group when it boots, and starts polling automatically.
When Auto-Startup is disabled, the 9150 establishes communication with the
RRMs in this group when it boots, but does not start polling in this RRM group until
a start polling command is received from the host.
Polling starts if at least one of the RRMs in the RRM group is operating when the
9150 boots.
Shared Channel
If this parameter is enabled ( √ ), the 9150 checks for other traffic on the radio
channel used by this RRM group, before polling.
If this parameter is disabled, the 9150 assumes that it has exclusive use of the radio
channel for this RRM group, and polls without checking for radio traffic.
This parameter is required for systems installed in the Netherlands.
POLLING PROTOCOL PARAMETERS
Warning: These parameters are pre-configured for your system, and should
not be changed without a proper understanding of how they affect
the radio link.