User's Manual

Teklogix 9150 Wireless Gateway User Manual 187
Chapter 6: Mini-Controller Configuration
ANSI/Telnet
Auto-telnet Host
This parameter contains the host name or IP address for the host to which the 9150
connects Auto-telnet sessions.
Note: A host name placed in this textbox must be “resolvable” by the 9150:
the 9150 must be able to obtain an IP address for it. For example, the host
name may correspond to an entry in the 9150’s host table, or the 9150
may be able to query a domain-name server.
Any host name which can be used at the terminal’s TCP> prompt may be
used here.
Auto-telnet Terminal Prompt
This parameter contains the text presented to the user to request a login. The charac-
ters can be any ASCII string, or a numeric escape sequence presented in octal or
hexadecimal digits.
An octal escape sequence takes one of the forms: \0d, \0dd, or \0ddd, where each ‘d’
can be any digit from 0-7. If ‘ddd’ is greater than decimal 256, the code value of the
represented character will be the remainder of the decimal ddd/256.
A hexadecimal escape sequence takes one of the forms: \xh or xhh, where each ‘h’
can be any digit from 0-9, or any alpha value from a-f or A-F.
Note: \0 is considered a character, with a code value of 0.
The allowable value is a maximum of 60 characters in the line. The default is no
text, just press <ENTER> to login.
Auto-login User ID
This parameter contains the user ID presented by the 9150 to the host for the
Auto-login sessions. The characters can be any ASCII string acceptable to the host,
with a maximum of 32 characters.
Auto-login Password
This parameter contains the password presented by the 9150 to the host for the
Auto-login sessions. The characters can be any ASCII string acceptable to the host,
with a maximum of 32 characters.