User's Manual

Teklogix 9150 Wireless Gateway User Manual 191
Chapter 6: Mini-Controller Configuration
RF Modem/Telnet
Function key n
The Function Key parameter allows you to select a code that will be sent to the host
when you press a function key on the terminal. Each function key may be chosen
from the same range of possible codes; however, each function key has a different
default code. The default values are shown on the screen above.
6.4.6 RF Modem/Telnet
RF Modem/Telnet is intended for a controller communicating with a Teklogix
Model 6040 RF Modem. The 6040 acts as a terminal on the Psion Teklogix network
to allow serial devices to communicate over that network (see the 6040 RF Modem
User Manual for details). Since the 6040 simply passes serial data through to con-
nected serial devices, there are no emulation or function key options. The 9150 dis-
plays this version of the Host Menu page after you have selected the RF
Modem/Telnet emulation/protocol combination for this host connection.
6.4.6.1 Emulation Options
These parameters are not applicable to the RF Modem emulation.
6.4.6.2 ANSI Telnet Protocol Options (RF Modem)
This page differs depending on the type of emulation and protocol selected in the
General Host Options page. The 9150 displays this version of the Protocol Options
page for the emulation/protocol combination RF Modem/Telnet for this host.