User's Manual

Chapter 7: 9100 Monitoring/Diagnostics
Diagnostics and Status Reporting
200
Teklogix 9150 Wireless Gateway User Manual
Low Current fault
A 9150DC that was previously being powered on this port has either been dis-
connected, or is not operating correctly. The 9100 will remove power from the
port and remain in this state for a minimum of two seconds before transitioning
to the OFF state. The port will continue to indicate the Low Current fault until it
either transitions to the ON state, or is disabled via the console.
High Current fault
A 9150DC that was previously being powered on this port is drawing too much
current from the 9100, or there is a short in the connecting cabling. The 9100
will remove power from the port and remain in this state for a minimum of five
seconds before transitioning to the OFF state. The port will continue to indicate
the High Current fault until it either transitions to the ON state, or is disabled via
the console.