User's Manual

Teklogix 9150 Wireless Gateway User Manual B-3
Appendix B: Port Pinouts And Cable Diagrams
RJ-45 Connector Pinouts (10BaseT/100BaseT Ethernet)
B.3 RJ-45 Connector Pinouts (10BaseT/100BaseT Ethernet)
Note: Usually, a straight-through connection is needed to connect Twisted-Pair
(10BaseT or 100BaseT) to the hub.
Important: For Main Logic Board (MLB) P/N 30183-301 Rev F only: When
connecting the RJ-45 Ethernet cable to the 9150T (AC power ver-
sion), ensure that the snap-on ferrite for cables (P/N 97776) is
placed on the cable as closely as possible to the RJ-45 jack. To
determine which version of the MLB is resident in your 9150,
please contact Psion Teklogix Support Services (see page A-1).
9150T 9150DC* 9100 PowerBaseT
Contact Signal Contact Signal Contact Signal
1 TD+ 1 TD+ 1 TD+
2TD
–
2TD
–
2TD
–
3 RD+ 3 RD+ 3 RD+
4 Not used 4 +48 VDC In 4 +48 VDC Out
5 Not used 5 +48 VDC In 5 +48 VDC Out
6RD
–
6RD
–
6RD
–
7 Not used 7 48 VDC Return In 7 48 VDC Return Out
8 Not used 8 48 VDC Return In 8 48 VDC Return Out
* The 9150DC can also accept 48 VDC power bias on the data line
pairs (1,2) and (3,6) from such systems providing power over Ethernet.