User's Manual

Teklogix 9150 Wireless Gateway User Manual 105
Chapter 5: Base Station Configuration
TekLAN Parameters
5.2.1.2 Wireless LAN Parameters
The Wlan protocol can only be used with spread spectrum radios.
Important: If your system is using the Wlan protocol, make sure that Operate
in Cellular Mode is enabled (see page 128) in the Radio Link Fea-
tures sub-menu and that cellular mode is also set on the 9400/
Network Controller.
Base Number
This parameter is used to assign a unique address to each base station. As the termi-
nals move from one base station to another, this address is transmitted by the base
stations to the terminals, identifying each 9150 on a multiple base station system.
The allowable range of base station numbers is 1 to 64.
Wired Network Connection
This parameter should be enabled ( √ ) if the 9150 is directly connected (wired) to
the network. If the 9150 is a wireless base station, this parameter should be disabled.
The default setting is enabled.
Timeout
This value is used to adjust Wlan performance and should be set to 10.