User's Manual

Chapter 2: Installation Requirements
LAN Installation: Ethernet
24 Teklogix 9150 Wireless Gateway User Manual
Functions
The 9100 PowerBaseT delivers 13 Watts per port for a total of 52 Watts. Power sup-
plied to each of the four Ethernet ports is protected from over-voltage and current
limiting within the power supply by the 9100’s microcontroller. Its primary
functions are:
1. Resistor Detection (described in Overview on page 22).
2. Fault Monitoring (page 197).
3. Power Monitoring (page 198).
4. Diagnostics and Status Reporting (page 198).
Status Indicators
The LEDs present at each port on the front panel of the 9100 (Figure 2.4 on page
22) indicate the status of the 9100 and the individual ports, as determined by the
microcontroller. Table 2.1 below shows the LED state meanings.
Note: Once a fault/abnormal condition is detected, the LED indicators will
continue to blink until the condition has been corrected, with or without
manual intervention.
Status Notes Yellow LED Green LED
Normal
Device present and
powered
On On
Normal / Fault
Device not connected /
not detected
Off On
Fault
Undercurrent fault
(device disconnected)
Slow blink On
Fault Overcurrent fault Fast blink On
Fault
9100 main power
supply fault
Fast blink (all ports) Fast blink (all ports)
Test Mode
Port in test mode
(enabled via console)
Fast blink Fast blink
Test Mode
Port disabled
(via console)
Off Slow blink
Table 2.1 LED Indicator States