User's Manual

Teklogix 9150 Wireless Gateway User Manual 25
Chapter 2: Installation Requirements
Status Indicators (LEDs)
2.2.4 Status Indicators (LEDs)
2.2.4.1 9150T and 9150DC
The high-performance 9150T (see page 20 for details) and DC-powered 9150DC
(see page 20 for details) both have six status indicators on the front of the enclosure,
and an additional two status indicators on the base of the enclosure next to the RJ-45
connector port, as shown in Figure 2.2 on page 19. The numbered and coloured
LEDs on the front of the unit indicate the operating status for each port, as described
in Table 2.2. The coloured LEDs beside the RJ-45 port indicate the operating status of
the resident 10BaseT/100BaseT card, as described in Table 2.3 on page 26.
LED
Number
Name Function Colour
1 Ethernet link
Link indicator for 10BaseT/100BaseT:
ON = good link; OFF = no link
yellow
2 Ethernet activity Ethernet LAN activity (Rx/Tx) green
3PC Card A status
1
PC Card A activity (Rx/Tx) yellow
4 PC Card B status
1
PC Card B activity (Rx/Tx) green
5SLIM
2
SLIM card activity yellow
6Power
LED flashing = BIST
3
running/error detected
LED On solid = BIST
3
Passed
LED Off = no power to unit
green
1
When a TekLAN 902 MHz radio is installed, the PC Card status LEDs blink only when
data is received from or transmitted to a terminal. When a TRX7370 narrow band radio is
installed, these LEDs blink for all received and transmitted data traffic.
(Note: the 9150DC only supports 802.11 radios.)
2
LED #5 shows no activity, since the 9150T and 9150DC do not support serial connectivity.
3
Built-in Self-Test.
Table 2.2 9150T And 9150DC LED Functions: Front Enclosure