User's Manual

Chapter 2: Installation Requirements
Connecting A Video Display Terminal
26 Teklogix 9150 Wireless Gateway User Manual
2.2.5 Connecting A Video Display Terminal
An ANSI compatible video display terminal (e.g., DEC VT220 or higher), or a PC
running terminal emulation, is used for diagnostic purposes and to configure the IP
address for the first time before the 9150 can be accessed using a Web Browser (see
“Configuring The IP Address” on page 29).
The terminal is connected to the port labelled “Console” on the 9150 (see Figure 2.2
on page 19). This port is normally set to operate at 19,200 baud, 8 bits, 1 stop bit, no
parity. To comply with Part 15 of the FCC rules for a Class B computing device,
only the cable supplied (Part no. 19387) should be used.
2.3 Changing The Configuration W ith A W eb Browser
The 9150 Flash memory can be reconfigured remotely via the network using a stan-
dard HTML Web Browser such as Netscape Navigator (version 4.05 or later) or MS
Internet Explorer (version 4.0 or later). See Chapter 3: “9150 Main Configuration”
for instructions on changing the parameters and general configuration settings.
For configuration information on setting up the 9150 as an access point device, refer
to Chapter 4: “Access Point Configuration”.
For configuration information on setting up the 9150 as a base station, refer to
Chapter 5: “Base Station Configuration”.
For configuration information on setting up the 9150 as a mini-controller, refer to
Chapter 6: “Mini-Controller Configuration”.
LED Colour Status Function
Green ON 100BaseT speed selected
Green OFF 10BaseT speed selected
Yellow ON Full duplex operation selected. (10BaseT or 100BaseT)
Yellow OFF Half duplex operation selected. (10BaseT or 100BaseT)
Table 2.3 9150T And 9150DC Ethernet LED Functions: Base Of Enclosure