User's Manual

Chapter 3: 9150 Main Configuration
Interfaces
34 Teklogix 9150 Wireless Gateway User Manual
3.4.1 Interfaces
The pull-down menu shown for the Interfaces option indicates which interfaces have
been detected in use by the 9150.
3.4.1.1 10BaseT Ethernet
For the selection 10BaseT Ethernet, entering the “Configure” dialog box will open
the Onboard Ethernet Parameters page for that Ethernet connection, which shows
the 9150’s physical (hardware) address and IP address parameters.
Physical Address
A unique Physical Address is assigned by Psion Teklogix personnel for each 9150.
The values entered for this parameter are presented in hexadecimal in descending
order beginning with the MSB (Most Significant Byte), the highest value, and
ending with the LSB (Least Significant Byte), the lowest value. The allowable value
for each field ranges from 00 to FF.
Warning: It is not advisable to modify the Physical Address. However, if these
values are changed, the Network Administrator must assign a
unique address to each Ethernet station on the network, including
all 9150s.