User's Manual

Chapter 3: 9150 Main Configuration
Interfaces
38 Teklogix 9150 Wireless Gateway User Manual
Media Speed and Operating Mode
You can choose the operational mode of the 9150T by selecting the media speed,
either 10 or 100 Mbps, and the operational mode, either full or half duplex. If the
parameter value is left at the default, Auto detection, the 9150T’s physical interface
will be detected, and the speed and mode will be set automatically.
Select the media speed and mode from the drop-down list. The values are:
Auto detection, 100 Mbps Full Duplex, 100 Mbps Half Duplex, 10 Mbps Full
Duplex, or 10 Mbps Half Duplex.
The default value is Auto detection.
Important: If the mode chosen for the 9150 is incorrect, it will become inac-
cessible from the network when it is rebooted. If this occurs, the
9150 will have to be re-configured using the console.
3.4.1.3 Slot n: PC Card Radio
Each PC (PCMCIA) card radio resident in the 9150 will be located in one of two
Slots: A or B. Selecting a PC card will open the sub-menu for that radio.
IEEE 802.11 DS: See “IEEE 802.11 Direct Sequence Radio Parameters Menu” on
page 62 for details on setting the radio parameters for the PC card.
TekLAN Card: See “TekLAN Parameters” on page 102 for details on setting the
radio and Wlan parameters.
Teklogix Narrowband: See “Narrow Band Radio Parameters” on page 106 for
details on setting the radio and polling parameters.