User's Manual

Chapter 3: 9150 Main Configuration
SNMP
40 Teklogix 9150 Wireless Gateway User Manual
Individual names and their assigned passwords may be changed or deleted in the
“Configure” dialog box for this option by selecting the name in the listbox
and then opening the “Configure” dialog box.
3.4.3 SNMP
SNMP (Simple Network Management Protocol) is the protocol that governs
network management and the monitoring of network devices and their functions,
including those in mapRF systems.
3.4.3.1 mapRF
The 9150 is fully compatible with mapRF management software. For complete
details on mapRF, please refer to the mapRF User Guide. When participating in a
mapRF system, manual configuration of the 9150 is minimal. The following param-
eters must be correctly configured:
• “10BaseT Ethernet” on page 34 and “100BaseT Ethernet” on page 36. The
IP address, default gateway and subnet mask must be correctly configured
for mapRF, either directly in the web pages or dynamically through
DHCP/Bootp (see “Network Interface Configuration Protocol” on page 52).
• SNMP must be enabled (see page 42).
Some parameters may need to be configured, depending on your firmware version.
These are listed below. To determine whether the firmware version in your 9150
already supports these parameters through SNMP, please contact Psion Teklogix
Support Services (see Appendix A: “Support Services And Worldwide Offices” ).
• “Serial Ports Parameters” on page 55.
• “Mobile IP Configuration” on page 93.
• “TekLAN Parameters” on page 102.
• “Narrow Band Radio Parameters” on page 106.
• “RRM Groups” on page 120.