User's Manual

Chapter 3: 9150 Main Configuration
SNMP
42 Teklogix 9150 Wireless Gateway User Manual
Enabled
When this parameter is enabled (√), the 9150 will respond to SNMP inquiries and
provide SNMP information. For the 9150 to operate with mapRF, the checkbox
must be enabled. The default setting is enabled.
3.4.3.3 Enable Proxy for non-IP terminals
When this parameter is enabled (√), the 9150 acts as the proxy with the mapRF
manager, for terminals without IP addresses. This option should be used only when
the 9150 is acting as the Cellular Master (mini-controller).
3.4.3.4 Proxy throttling
To ensure that increased radio traffic due to the 9150 acting as proxy does not create
a problem, the amount of traffic can be controlled by setting it to 100, 500, or 1000
bytes per second. The default is Disabled.
3.4.3.5 SNMP Communities and Trap Receivers
These parameter settings allow the network administrator to define the network
environment and determine the type of access allowed (read_only or read_write)
for each area name and IP address. The Name entries should be of 7-bit, US-ASCII
character type and not more than 255 characters. The trapDest IP addresses deter-
mine which SNMP manager’s stations will receive SNMP Traps from the 9150.