User's Manual

Teklogix 9150 Wireless Gateway User Manual 49
Chapter 3: 9150 Main Configuration
TCP/IP Parameters
3.4.6.1 Route Table
Routing Table
The routing table is used when the 9150 and the host are not connected directly on a
single physical network segment.
Packets are routed between network segments to the network connections,
depending on the packets’ destination addresses and on the contents of the 9150’s
Host and Routing tables.
To add an entry to the 9150’s routing table, select “Configure” beside “[#] Add
Entry” in the listbox. This will open the New Routing Table Entry menu.
New Routing Table Entry
Entry Name
This is the designated name of the entry.
Destination Type
Select a destination type for this entry from the drop-down list, either Host or Net.
Router IP Address
Enter the router’s IP address in this textbox. This device must be on the same subnet
as the 9150, and must be capable of sending packets to the host. If the host is on
the same subnet as the 9150, enter its address here and in the Destination IP
Address textbox.
Destination IP Address
Enter the IP address of the host. If the host is on the same subnet as the 9150, enter
its address here and in the Router IP Address textbox.