User's Manual

6 Psion Teklogix RD7950 Quick Start Guide
Attaching The Pistol Grip
Notes: A Phillips head screwdriver is required. Do not use adhe-
sives such as Loctite to secure the screws on carrying acces-
sories. These chemicals may damage the plastic casing.
The pistol grip is attached to the back of the 7535 Hand-Held
Computer using the four threaded inserts in the upper part of the
7535 casing.
Four black #4-40 Phillips head screws are provided with this acces-
sory: two for insertion into the bottom holes, and two for insertion
into the top holes through the RD7950 when attaching it to the 7535/
pistol grip assembly (see page 7).
Note: Prior to installation, make sure the trigger mechanism is
securely snapped into the pistol grip body and that the
trigger operates properly.
• Position the pistol grip so that it fits snugly over the back of the
unit and the inserts on the back of the 7535 align with the holes
in the pistol grip.
• Using a Phillips screwdriver, securely fasten the pistol grip to
the two bottom holes on the back of the 7535. Tighten the
screws to a torque of 3kgf-cm (3 lbs-in), or until finger-tight, to
secure the pistol grip in place.