Specifications

PSP Xenon Quick Start

If you are so excited to start playing with PSP Xenon you can’t read through the manual first,

here are some quick steps to get you going:

1.Instantiate the PSP Xenon into an insert slot in your host DAW.

2.Verify the Power button of the PSP Xenon editor is illuminated (ON).

3.Start playback on your host DAW.

4.Adjust the in knob, driving the limiter, until you get a solid signal coming into PSP Xenon.

5.Adjust the transient knob to set the attack time and the amount of transients passed to

the second processing stage.

6.Choose to the desired transients processing mode (react or any of the two predict modes)

7.Adjust the release knob to set the perceived loudness and find the balance between loud-

ness and distortion.

8.Set the leveler knob to reduce pumping artifacts, if there are present.

9.Set the out knob to the desired output (ceiling) level.

As you can see, getting up and running with PSP Xenon is quite intuitive. But these steps,

while enough to get you started, don’t reveal the true power and creative potential of this plug-

in. For that, keep reading the rest of this manual.

Remember: the manual is your friend! Please use this as a reference whenever you need

more detail. Also, look out for these shaded boxes for important notes, tips, and cautions.

PSP Xenon Operation Manual