User's Manual

18G 4x1 Presentation Switcher with Soft Codec & Wireless BYOD

7. Firmware Upgrade

Please follow the steps as below to upgrade firmware by the FW port on the rear

panel:

1) Prepare the latest upgrade file (.bin) and rename it as “FW_MERG.bin” on PC.

2) Power off the switcher, and connect the FW port of switcher to the PC with USB

cable.

3) Power on the switcher, and then the PC will automatically detect a U-disk named of

“BOOTDISK”.

4) Double-click the U-disk, a file named of “READY.TXT” would be showed.

5) Directly copy the latest upgrade file (.bin) to the “BOOTDISK” U-disk.

6) Reopen the U-disk to check the filename “READY.TXT” whether automatically

becomes “SUCCESS.TXT”, if yes, the firmware was updated successfully,

otherwise, the firmware updating is fail, the name of upgrade file (.bin) should be

confirm again, and then follow the above steps to update again.

7) Remove the USB cable after firmware upgrade.

8) After firmware upgrade, the switcher should be restored to factory default by

sending command.