User manual

Scaler Wall Plate HDBaseT Transmitter
PTN Electronics Limited 3 www.PTN-electronics.com
source

turn off when there is no VGA input signal
⑥ AUDIO IN
Connect with the audio output socket of VGA source device,
deliver synchronous audio source with VGA signal source when
choosing VGA as source signal.
⑦ HDMI IN
Connect with HDMI source device.
The indicator will illuminate yellow when there is VGA signal
input and illuminate green when the signal source is chosen as
input source.
⑧
LINK
&HDCP
 LINK: Twisted Pair Link status indicator, illuminate green
when successfully connected.
 HDCP: HDCP compliance indicator, illuminate green when
the source signals is with HDCP; blink when it is not with
HDCP; and turn off when there is no source signal.
⑨ RESET
Press the button to reboot TPHD405PT-WPI.
⑩ FIRMWARE
USB port, used for firmware update
Plug a flash disk or other storage device with update file
(MERGE.bin), and send command 50698% to update firmware.
2.2 Side Panel
① HDBT OUT: RJ45 port, connect with receiver via a CAT5e/6 cable to deliver Audio/
Video signals, support PoC.
Note: TPHD405PT-WPI support unidirectional PoC, i.e. it can be energized by far-end
receiver but it can’t energize far-end receiver.
2.3 Rear Panel