User's Manual

Page 35 of 58
Rev 1.4 7/19
7. SETUP
Move the cursor to the Setup item in the main menu and
press [HOME] button, SETUP menu appears, as shown in
the following figure.
Language: Menu language, Optional items: EN, Chinese,
Russian
DVIMode: Digital signal type for HDMI port, Optional
items: DVI, HDMI
Protocol: Control protocol type. Optional items: AUTO,
VISCA, PELCO-D, PELCO-P
V_Address: VISCA address, Decided according to the
argument of Protocol; Optional items: VISCA
(1~7), PELCO-D (0~254), PELCO-P (0~31)
P_D_Address: PELCO-D address; Optional items:
0 ~ 254
P_P_Address: PELCO-P address; Optional items:
0 ~ 31
V_AddrFix: Lock IR Address from changing via serial
control, Optional items: On, Off（When set to On,
88 30 01 FF Command will not function）
Net Mode: Set the serial port control networking,
Optional items: Serial, Paral (parallel)
Baudrate: Serial port baud rate. Optional items: 2400,
4800, 9600
8. RESTORE DEFAULT
Move the cursor to the Restore Default item in the main
menu and press [HOME] button, RESTORE DEFAULT
menu appears, as shown in the following figure.
Restore: Reset all settings to factory default settings.
Optional items: Yes, No
Note: Press [HOME] button to confirm, All parameters
are then restored to default values, including IR Remote
address, VISCA Address and Pelco addresses.
9. Saving
Save: Save setting changes. Optional items: Yes, No
RESTORE DEFAULT
Restore? No
Change Value
[Home] OK
[Menu] Back
SETUP
Language EN
DVIMode DVI
Protocol VISCA
V_Address 1
V_AddrFix Off
Net Mode Serial
Baudrate 9600
Select Item
Change Value
[Menu] Back