User's Manual

Page 49 of 58
Rev 1.4 7/19
2) Port Settings
While the IP address identifies the device, the camera uses multiple ports.
HTTP Port: This is the port for the web application (the default http port: 80)
RTSP Port: The camera supports the RTSP streaming protocol. The default port: 554.
PTZ Port: Supports camera control via the TCP protocol. The default port: 5678.
3) Control Protocol Settings
Control addresses for VISCA (1-7), Pelco-D (0-254) and Pelco-P (0-31) may be set here.
4) RTMP settings
RTMP streaming may be enabled for 2 separate streams to a streaming server (or servers). Note: A separate
streaming server is required for use of RTMP streaming. Set 1
st
and 2
nd
stream to ‘On’ or ‘Off’, check to
include video and/or audio and type in the address and port or domain of the streaming server (MRL - Media
Resource Locator).
5) RTSP Authorization
Turn authorization ‘On’ or ‘Off’ for RTSP streaming.
6) ONVIF Setting
Turn On/Off ONVIF and ONVIF auth.
7) Multicast Setting
Turn Multicast streaming ‘On’ or ‘Off’ (Note: Do not attempt to use Multicast streaming unless your network
has been setup and tested to support multicast, e.g. IGMPv3. Significant network performance issues may
result otherwise. Also note: The public internet does not support multicast streaming).
Address and Port Settings: enter the multicast address and port to be used.
8) Apply and Cancel Buttons
After modifying the parameters, press the "Apply" button to save. Press the "Cancel" button to leave settings
unchanged.