User's Manual

9. There is a 35cm space between the two robots placed side by side at the standby point,
and a clearance of 15cm from the rear wall and 35cm from the side wall.
15CM
35CM
35CM 35CM 35CM
*因不当操作所引发的所有意外，本公司不承担任何责任。
10. It is necessary to add fences or other blocking protection at the locations, such as
the edge of the stairs and entrance of the downhill, where there is a risk of the robot
falling.
1. When the remaining power of the robot is less than 10%, please charge it in time, as low
battery operation for a long time may shorten battery life.
2. After charging, please disconnect the power supply in time, be sure not to charge for a
long time when the robot is fully charged.
3. If the robot is not used for a long time, please power off the product in time to protect
the battery.
4. ALWAYS use the original rechargeable battery and charging device, NEVER use a non
genuine charger to charge the robot.
5. Charge the main unit according to the power supply voltage indicated on the nameplate
of charger.
6. Make sure that the power supply voltage meets the voltage indicated on the charger,
otherwise the charger may be damaged.
7. Carefully protect the power cord from pulling and twisting.
8. Please designate a full-time staff to charge the robot, be sure not to charge it unattend-
ed.
9. Be sure not to charge the robot near flammable or explosive objects.
10. Please keep the robot's storage and charging position dry and at normal temperature,
it is strictly prohibited to place the robot and charger in high temperature area (＞40℃),
and it is forbidden to allow water entering the robot and charger.
11. It is strictly forbidden that the charger collides with foreign objects, causing damage to
the charger.
12. If the charger is found damaged or the charging current is abnormal, please replace
the charger in time.
13. When receiving a robot alarm, disconnect the charging device immediately.
Power and power requirements
User manual User manual
7 8