Instruction manual

Page 6
Connectors
TM-1405GE Software
2 Connectors
The camera has two sockets, as shown in Figure 6 below:
• 12-pin Hirose for power, trigger, RS-232 communication and TTL I/O.
• RJ-45 for Gigabit Ethernet.
Figure 6. TM-1405GE Back Panel Connectors
These connectors are described in Section 2.1 and Section 2.2 below.
2.1 Power and Signals Connector
The GE camera receives power and signal through a 12-pin Hirose connector. Table 1 below lists the
pin layout and describes the function of each pin. The table lists the GPIO assignments for the relevant
pins. A magnified illustration of each pin’s assignment follows in Figure 7 on page 8.
Table 1. Hirose Connector, Pin Assignment
Pin # Definition Description GPIO Assignment
1 GND Power ground
2 +12V Power supply in
3 AGND Analog ground (video)
4 VIDEO Video out
5 GND Ground (TTL) - Digital
6
TTL IN
(EXT_TRIG)
VINIT in (CC1 equivalent) I0
7
TTL IN
(EXT_VD)
VD in (CC4 equivalent) I1 (can bypass GPIO LUT)
8
TTL OUT
(STROBE)
Strobe output Q0
9
TTL IN
(EXT_HD)
HD in (CC3 equivalent) I2 (can bypass GPIO LUT)
10 RESV Reserved
11 RESV Reserved I3
12 RESV Reserved
GigE
POWER