Replacement Part List

1800 PSI Pressure Washer
01
Automatic On / Off
The pressure washer is equipped with an automatic on/off switch.The pressure washer
will only run when the power switch is in the ON position and the trigger on the gun is
squeezed. When you release the trigger to stop spraying water through the gun, the
motor on the pressure washer will automatically shut off. Simply squeeze the trigger
again to resume using the washer. To stop using the pressure washer, release the
trigger and switch the unit to the OFF position. The unit should be turned completely
OFF while not in use or while unattended.
Bleeding The Gun
It is very important to bleed all the air out of the pressure washer before using it.To do this
1. Release trigger lock.
2. Squeeze the trigger before turning the electrical supply on.This removes any air trapped
inside the pressure washer and lance before using the units.
3. Continue holding trigger for approximately one minute to allow any excess air out of the
unit.Water will flow through the gun at low pressure during this procedure.
4. Lock the trigger.
5. Plug the main power cord into the electrical outlet.
6. Release the trigger lock.
7. Turn the ON/OFF switch clockwise to the I/ON position.
The pressure washer is ready for operation.
Gun Safety Lock
This pressure washer is equipped with a gun trigger safety lock. When not using the
pressure washer, use the safety lock to protect from accidentally engaging the high
pressure spray.
Adjustable Spray Nozzle
The adjustable nozzle will allow you to use a variety of spray patterns from a full fan
spray (Diagram 1) to a direct stream spray (Diagram 2). When using the pressure washer
to clean wood decks, siding, vehicles etc., always start using the fan spray and begin
spraying from a minimum 36” away to avoid damaging the surface of the material you are
cleaning. Always begin by spraying in a test area free and clear of people and objects.
Low Pressure Setting
11
Dispensing Detergent
The built-in detergent dispenser will allow you to apply liquid detergent
onto the work surface. Detergent application happens at low-pressure only. Insert the
adjustable nozzle onto the gun, and turn it to end of “ - ” so that the pressure washer
is in low-pressure mode (see Figure A below). Remove the cap on the detergent
reservoir and fill with liquid detergent only (see Figure B below). Do not put any water
into the reservoir. The pressure washer will mix water and detergent automatically.
When finished applying the detergent to the work surface, turn it to end of “ + ” of
the adjustable nozzle and spray off the detergent by using the high-pressure spray
(see Figure A below). In high-pressure mode, the pressure washer will not dispense
detergent.
FIGURE A
High Pressure Setting
1800 PSI Pressure Washer
FIGURE B
Diagram 2
Diagram 1