ANALOGUE WATCHES Unlocking the crown 1 Turn Crown counterclockwise until you no longer feel the threads turning. 2 Crown can be pulled out. Locking the crown 1 Push Crown back in to normal position. 2 Turn Crown clockwise while pressing it lightly until tight. * When using the watch in water: Before using the watch in water, be sure the crown is screwed in completely. Do not operate the crown when the watch is wet or in water.
■ HOW TO START THE MECHANICAL WATCH (Cal. Y621) To initially start your watch, swing it from side to side in a horizontal arc for about 30 seconds. * If the watch is worn daily, PULSAR’s automatic mechanism will wind the mainspring automatically through normal wrist movement. English ■ TIME SETTING FOR MODELS WITHOUT CALENDAR CROWN 1 Pull out. 2 Turn to set the time. 3 Push back. ■ TIME/CALENDAR SETTING FOR MODELS WITH DATE CALENDAR CROWN 2 1 Pull out to the first click.
2 Turn to show the previous day’s date. 3 Pull out to the second click. 4 Turn until the desired date appears. * Turn Crown to advance Hour and Minute hands. 10 5 Turn to set the time. 6 Push back in to normal position. CROWN 1 Pull out to the first click. 2 Turn to show the previous day’s date. 3 Turn in the opposite direction to show the previous day of the week. 4 Pull out to the second click. 5 Turn until the desired date and day appears.
* Turn Crown to advance Hour and Minute hands. English 6 Turn to set the time. 7 Push back in to normal position. 4 Notes on time setting: 1 When setting Minute hand of a quartz watch, advance it a few minutes ahead and then turn it back to the exact time. 2 If your watch has three hands, pull out Crown all the way when Second hand points at 12 o’clock. After adjusting the time, push Crown back in to normal position in accordance with a time signal for “00” seconds.
● As the battery is inserted at the factory to check the function and performance English of the watch, its actual life once in your possession may be less than the specified period. ● When the battery expires, be sure to replace it as soon as possible to prevent any malfunction. ● We recommend that you contact an AUTHORIZED PULSAR DEALER for battery replacement. WARNING ● Do not remove the battery from the watch. ● If it is necessary to take out the battery, keep it out of the reach of children.
CAUTION English ● The battery is not rechargeable. Never attempt to recharge it, as this may cause battery leakage or damage to the battery. ● Loss/gain (monthly rate) is less than 15 seconds (20 seconds for some calibres) at normal temperature range (5°C ~ 35°C)(41°F ~ 95°F).
WATER RESISTANCE ● Water resistance (5 bar)* English If “WATER RESISTANT 5 BAR” ● Non-water resistant is inscribed on the case back, your If “WATER RESISTANT” is not watch is designed and manuinscribed on the case back, your 5 bar WR factured to withstand up to 5 bar watch is not water resistant, and care should be taken not to get it and is suitable for swimming, yachting and taking wet as water may damage the movement. If a shower.
English * Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the crown is pushed in completely. Do not operate the crown when the watch is wet or in water. If used in sea water, rinse the watch in fresh water and dry it completely. * When taking a shower with the water resistance 5 bar watch, or taking a bath with the water resistance 10, 15 or 20 bar watch, be sure to observe the following: • Do not operate the crown when the watch is wet with soapy water or shampoo.
CARE OF CASE AND BRACELET To prevent possible rusting of the case and bracelet caused by dust, moisture and perspiration, wipe them periodically with a soft dry cloth. SHOCKS & VIBRATION CHEMICALS Be careful not to expose the watch to solvents, mercury, cosmetic spray, detergents, adhesives or paints. Otherwise, the case, bracelet, etc. may become discolored, deteriorated or damaged. The watch will be adversely affected by strong magnetism. Keep it away from close contact with magnetic objects.
