CAL. 3M22 ® ● ● ● ● ● ● KINETIC E. S. U.
DISPLAY AND CROWN/BUTTON Minute hand Hour hand BUTTON CROWN a b Second hand c Date a: Normal position 2 b: First click c: Second click
SCREW DOWN CROWN [for models with screw down crown] Unlocking the crown 1 Turn Crown counterclockwise until you no longer feel the threads turning. 2 Crown can be pulled out. Locking the crown 1 Push Crown back in to normal position. 2 Turn Crown clockwise while pressing it lightly until tight.
HOW TO CHARGE AND START THE WATCH 1 Swing the watch from side to side. * Swing rhythmically at a rate of twice a second. 2 Charge the KINETIC E. S. U. sufficiently. 3 Set the time/calendar and put on the watch.
✽ Power reserve accumulated while you are walking 80 m 3 hours ✩ ➡ ➡ Power reserve 400 m ★ Wearing the watch. 1 day ✩ The second hand starts moving at one-second intervals. ✰ The illustration provides only a general guideline of the relationship between the power reserve and the distance you walk. Actual amount of power reserve differs from person to person.
POWER RESERVE INDICATOR BUTTON 5 seconds Between 2 and 3 days ➧ Between 1 and 2 days 30 seconds ➧ Between 3 and 24 hours 20 seconds ➧ POWER RESERVE 10 seconds ➧ QUICK MOVEMENT OF SECOND HAND ★ Press the button at the 2 o’clock position. More than 3 days ★ The second hand will resume normal movement after the indicated 5, 10, 20 or 30 seconds have elapsed.
FULL CHARGE OF THE KINETIC E. S. U. ● When the KINETIC E. S. U. is fully charged, the watch will keep operating for a maximum of 6 to 7 days without recharging the KINETIC E. S. U. REMARKS ON THE KINETIC E. S. U. ● Even while the second hand is stopped by pulling out the crown, current continues being consumed by the built-in IC. Therefore, pulling out the crown will not save the energy stored in the KINETIC E. S. U.
ENERGY DEPLETION FOREWARNING FUNCTION ● When the second hand starts moving at two-second intervals instead of the normal one-second intervals, the watch will run down in approximately 3 hours. In this case, swing the watch from side to side to charge the KINETIC E. S. U. sufficiently. INSTANT-START FUNCTION ● When a long time has passed since the watch stopped, you can get it started quickly with only a few swings.
TIME/CALENDAR SETTING CROWN Second hand 1 Pull out to first click and set the previous day’s date. 1 ➠ 2 ➠ ➠ 5 3 4 2 Pull out to second click when the second hand is at the 12 o’clock position. 3 Turn to set the desired date. 4 Turn to set the hands to the desired time. 5 Push back completely in accordance with a time signal.
ROTATING BEZEL (for models with rotating bezel) ● The rotating bezel can show up to 60 minutes of elapsed time. 1 Turn the rotating bezel to align its “ ” mark with the minute hand. * For some models, the rotating bezel rotates only counterclockwise. ➡ Elapsed time 10 Start 30 minutes have elapsed. 2 Read the number on the rotating bezel that the minute hand points to.
NOTES ON OPERATING THE WATCH HOW TO CHARGE AND START THE WATCH ● To charge the KINETIC E. S. U. efficiently, swing the watch from side to side, making an arc of about 20 cm. ● No additional benefit is obtained by swinging the watch more quickly or with greater vigor. ● When the watch is swung, the oscillating weight in the generating system rotates to drive the mechanism. As it rotates, it gives out a sound, which is not a malfunction. ● The watch is equipped with a system to prevent overcharge.
time. To do so a third time, however, wait until the second hand resumes normal movement before pressing the button again. ● When the second hand moves at two-second intervals, the power reserve is very low and the indicator does not function. ● Immediately after the watch is swung to charge the KINETIC E. S. U., the second hand may not properly indicate the power reserve. Please check after putting the watch on your wrist.
the A.M. or P.M. period. If the date changes, the time is set for the A.M. period. If the date does not change, the time is set for the P.M. period. ● When setting the minute hand, advance it 4 to 5 minutes ahead of the desired time and then turn it back to the exact minute. ● When setting the time, make sure that the second hand is moving at one-second intervals. ● It is necessary to adjust the date at the end of February and 30-day months.
TO PRESERVE THE QUALITY OF YOUR WATCH WATER RESISTANCE ● Non-water resistant • If the watch becomes wet, have it checked by an AUTHORIZED PULSAR DEALER or SERVICE CENTER. ● Water resistant 5/10/15/20 bar 5 bar WR 10/15/20 bar WR 14 • Before using in water, be sure the crown is pushed in completely. • Do not operate the crown and button when the watch is wet or in water. If used in sea water, rinse the watch in fresh water and dry it completely.
* Pressure in bar is a test pressure and should not be considered as corresponding to actual diving depth since swimming movement tends to increase the pressure at a given depth. Care should also be taken on diving into water. ** We recommend that you wear a PULSAR Diver’s Watch for scuba diving. TEMPERATURES Your watch works with stable accuracy within a temperature range of 5° -10°C C and 35° C (41° F and 95° F).
SHOCKS & VIBRATION PERIODIC CHECK Light activities will not It is recommended that the affect your watch, but be watch be checked once 2-3 careful not to drop your every 2 to 3 years. Have Years watch or hit it against hard your watch checked by an surfaces, as this may AUTHORIZED PULSAR cause damage. DEALER or SERVICE CENTER to ensure that the case, crown, button, gasket and crystal seal remain intact.
