User Manual

Specs:
Size: 3.22 x 1.53 x 0.7 inches
(82 x 39 x 18mm)
Maximum Cartridge Size: 0.55 inches diameter,
2.4 inches length (14mm x 61mm)
Battery Capacity: 650mAh
Voltage: 2.8V / 3.4V / 3.8 (1.8V Pre-heat)
Charging: USB-C
Resistance: 0.8-2.0 Ω
Kit Includes:
1 x Pulsar 510 DL 2.0 Battery
1 x Bottom Magnetic Connector
Power On/Off:
Quickly pull - draw in air, within 1.5 seconds - from mouthpiece 5 times
to switch the power on or off. The light will ash once. You can also
press the button on the bottom 5 times for on/off.
Pre
-
heating:
Quickly pull from mouthpiece twice to activate the pre-heat function.
You can also press the button on the bottom 2 times to activate
pre-heat function.
Charging:
Charging: Red light
Fully charged: Green light
Low Battery: Red light will ash 10 times to alert user, and will then enter
standby mode. Charge before continuing use.
Protection Features:
Battery life/cartridge protection: After 10 continuous seconds of use,
the red light will ash 4 times, and the automatic vape time cutoff will
activate, turning off the heat (but not the power).
Over-voltage/short-circuit protection: red light will ash 3 times, and
device will fully turn off.
Pulsar 510 DL 2.0 Auto
-
Draw Variable Voltage Vape Pen
|
MANUAL
Quick Start instructions
1. Connect your device to a power source and charge until the light turns green.
2. Insert the 510-threaded cartridge of your choice.
3. Quickly pull 5 times to power on the device or press power button 5 times.
4. Quickly pull 3 times to change voltage to your preferred temp or press power
button 3 times.
5. Quickly pull twice to start pre-heating or press power button 2 times.
6. Pull from mouthpiece and enjoy.
Instructions:
1. Make sure that the bottom magnetic connector is properly connected to the
bottom of the unit. The battery will not charge if the bottom connector is not
attached.
2. Plug into a USB-C cable and connect to a power source. You will see the light ash
once when the battery is connected.
3. Allow the battery to fully charge before rst use. The light will turn green.
Disconnect the device from the power source before use.
4. Remove the bottom magnetic connector and rmly screw in the 510-threaded
cartridge of your choice.
5. Insert the cartridge into the device and ensure that the bottom magnetic
connector is properly reconnected.
6. If the unit is powered off, place your lips on the mouthpiece and give it 5 quick
pulls to power on or press power button 5 times.
7. Adjust the voltage by giving the unit 3 quick pulls or press power button 3 times.
8. Activate the pre-heat function to prime the cartridge by giving the unit 2 quick
pulls or press the power button 2 times. This will activate the unit at 1.8V for 15
seconds. After 15 seconds, the unit will switch to your previously selected voltage.
9. Simply pull from mouthpiece to activate the cartridge vapor and enjoy your
session!
Cleaning Instructions:
1. Remove the bottom magnetic connector from the battery.
2. Wipe the outside and inside of the bottom magnetic connector
with an isopropyl alcohol pad. Use an alcohol swab to wipe any
excess oil out of the 510 screw-in connector.
3. Clean the inside air pathway with an alcohol swab.
Using a circular motion, work your way up and down the
air pathway until you do not see any more oil.
4. Do not submerge any part of the device in cleaning
solution. Allow all parts to air dry prior to resuming use.
!
The mouthpiece is NOT removable.
Attempting to remove it could impair
or permanently disable the breath
control functionality.
Scan the QR code on packaging for the most current version of the manual, or go to https://www.pulsarvaporizers.com/pages/manuals
PulsarVaporizers.com
Manufactured by Pulsar
®
Asheville, NC 28806
Designed in USA, Made in China
Power Check:
Press bottom button once to
check battery power level.
Green light: 75%
Blue light: 35%-75%
Red light: 35%
Change Voltage Setting:
Quickly pull from mouthpiece
3 times to change the setting.
Green Light: 2.8V
Blue Light: 3.4V
Red Light: 3.8V
Important Safety Warnings
• Do not expose to extreme temperatures or direct sunlight.
• Do not drop the device or accessories.
• Do not drop or submerge in any liquid.
• Do not modify the electronics in any way.
• This device is intended for adults only. Do not sell or provide to minors. Keep all parts, concentrates, herbs, and liquids
away from children and pets. This is not a medical device and is not intended to diagnose, treat, mitigate, cure, or prevent
any ailment, disease, or other conditions. Consult a physician before use, especially if you suffer from heart disease or any
other medical condition, or if you are pregnant or breastfeeding. Failure to follow any of these instructions could result in
product damage, property damage, personal injury, and may void warranty.
PU-0519-22