Operation Manual
English
English
1312
MAGNETISM
N
S
Your watch will be
adversely affected by
strong magnetism. Keep
it away from close contact
with magnetic objects.
Be careful not to expose
the watch to solvents,
mercury, cosmetic spray,
detergents, adhesives or
paints. Otherwise, the
CHEMICALS
case, bracelet, etc. may become
discolored, deteriorated or damaged.
Light activities will not
affect your watch, but be
careful not to drop your
watch or hit it against hard
surfaces, as this may
SHOCKS & VIBRATION
cause damage.
To prevent possible rusting of
the case and bracelet caused
by dust, moisture and
perspiration, wipe them
periodically with a soft dry cloth.
CARE OF CASE AND BRACELET
It is recommended that the
watch be checked once
every 2 to 3 years. Have
your watch checked by an
AUTHORIZED PULSAR
2 - 3
Years
PERIODIC CHECK
DEALER or SERVICE CENTER to
ensure that the case, crown, buttons,
gasket and crystal seal remain intact.
PRECAUTION REGARDING
CASE BACK PROTECTIVE FILM
If your watch has a
protective film and/or a
sticker on the case back,
be sure to peel them off
before using your watch.
* Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the
crown is pushed in completely.
Do not operate the crown when the watch is wet or in water. If used in sea water,
rinse the watch in fresh water and dry it completely.
* When taking a shower with the water resistance 5 bar watch, or taking a bath with
the water resistance 10, 15 or 20 bar watch, be sure to observe the following:
• Do not operate the crown when the watch is wet with soapy water or shampoo.
• If the watch is left in warm water, a slight time loss or gain may be caused. This
condition, however, will be corrected when the watch returns to normal
temperature.
NOTE:
Pressure in bar is a test pressure and should not be considered as corresponding
to actual diving depth since swimming movement tends to increase the
pressure at a given depth. Care should also be taken on diving into water.
TEMPERATURES
+60°C
-10°C
Do not leave your watch in very low
temperatures below –5° C (+23°F) for
Your watch works with
stable accuracy within a
temperature range of 5°
C and 35°C (41°F and
95°F).
a long time since the cold may cause
a slight time loss or gain.
However, the above conditions will
be corrected when the watch returns
to normal temperature.
7S26_E 05.3.16, 3:23 PM12-13