Operation Manual

Remove the IR from the carrying case.
Turn the knob of the battery cover 90° counterclockwise, remove the
cover and install two AA batteries as indicated (see illustration). Close
the cover and lock.
Attach the IR illuminator to the Weaver rail (1) and tighten the locking
screw.
Switch on the IR Illuminator by pushing the “ON/OFF” button (2), the
red LED indicator (5) lights up.
To adjust the beam from spot to flood, rotate the lens holder (3) until
you get the best image through your night vision riflescope/device.
To adjust the IR power, rotate the controller (4).
After use switch off the IR by pushing the “ON/OFF” button (2) - the red
LED indicator goes out.
The housing of the flashlight can be cleaned with a soft cloth. Do not
use an abrasive cloth/chemical cleaning solutions. Always use
cleaning equipment designed for photographic equipment. Dust can
be removed from the lens with a soft brush. The lens can be cleaned
with any cloth designed for cleaning optical equipment. Do not pour
lens cleaner on the lens itself!
adjust beam from spot to flood;
smoothly adjust power depending on viewing conditions.
The IR Flashlights are equipped with a standard Weaver mount which allows
you to affix the auxiliary IR to Pulsar devices with a Weaver rail. The Pulsar-
805 is suitable for use with analog night vision riflescopes (such as the
Sentinel Gen.1, Sentinel GS, Sentinel G2+, Phantom G2+), and
monoculars (e.g. the Challenger series). The Pulsar-940 can be employed
with digital riflescopes Digisight N550 and digital monoculars (e.g. units of
the Recon series). You can also use them as hand-held units.
Note: If you need to adjust the IR spot position, turn the locking ring (6)
5-10 degrees counter-clockwise. Match the IR spot with the image
viewed through a night vision device by moving the IR lens holder (3)
transversely. Tighten the locking ring (6).
Caution! During operation rings of the radiator become hot, which is normal
and is not a defect .
3
Инфракрасные фонари Pulsar-805 и Pulsar-940 предназначены для
дополнительной подсветки лучами ИК диапазона (невидимыми – в Pulsar-940)
объектов наблюдения при использовании приборов ночного видения в
условиях, близких к полной темноте (отсутствие луны ночью, сильная
облачность и т.д.). Применение фонарей Pulsar позволяет:
существенно увеличить дальность наблюдения;
производить безошибочную идентификацию объекта наблюдения;
детально рассмотреть любой выбранный объект;
регулировать размер светового ИК-пятна в зависимости от
дистанции;
79071
24
200
0-2003
805
5,7-10
3 (2xAA)
2
- 20°С ...+40°С
132x45x52
140/190
 79076
24
200
0-2003
940
5,7-10
3 (2xAA)
2
- 20°С ...+40°С
132x45x52
140/190
ИК-фонарь Pulsar-805/940
Чехол
Две батареи типа АА
Переходник для установки на приборы с гнездом 1/4”
Салфетка для чистки линз
Инструкция по эксплуатации
22