1600 PSI Pressure Washer Table Of Contents Topic Page # Important Safety Tips, Precautions, Warnings, and Usage Instructions 2-5 Assembly Instructions 6-8 Operating Instructions 9-12 Detergents 12-13 Clean-up and Storage 14-15 Cleaning Tips 16 Technical Data 17 Troubleshooting Tips 18 Limited Warranty 19~20 Parts 21~22 1
1600 PSI Pressure Washer GROUND FAULT CIRCUIT INTERRUPTER (GFCI) This pressure washer is provided with a ground fault circuit interrupter (GFCI) built into the plug of the power supply cord. This device provides additional protection from the risk of electric shock. Should replacement of the plug or cord become necessary, use only identical replacement parts that include GFCI protection. This unit is equipped with a Ground Fault Circuit Interrupter (GFCI).
1600 PSI Pressure Washer IMPORTANT SAFETY PRECAUTIONS WARNING: When using this product, basic precautions should always be followed, including the following: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. Read all instructions before using the product. Save all safety instructions. Do not operate the pressure washer when fatigued or under the influence of alcohol or drugs. Risk of injection or injury – do not direct the high pressure water stream at any people or animals.
1600 PSI Pressure Washer 5. 6. 7. 8. 9. Read all instructions included with the mask so you are certain the mask will provide the necessary protection against inhaling harmful vapors. Before starting the pressure washer in cold weather, check all of the parts of the equipment and be sure that ice has not formed. Do not store the unit anywhere that the temperature will fall below 0 ° C (32 ° F).
1600 PSI Pressure Washer electrical rating not less than the rating of the product. Examine extension cord before use. Do not use damaged extension cords! Do not pull on cord to disconnect from receptacle, always disconnect by pulling on plug. Keep cord away from heat and sharp edges. Always disconnect the extension cord from the receptacle before disconnecting the product from the extension cord. WARNING – To reduce the risk of electrocution, keep all connections dry and off the ground.
1600 PSI Pressure Washer ASSEMBLY INSTRUCTIONS Unpacking The Carton After opening the carton, please remove all parts and check them against the following list of components that are included: A. High Pressure Washer B. Gun C. High Pressure Hose D. Adjustable Nozzle E. Water Intake Filter (Pre-Installed) F. Two-way Hose Connector G.
1600 PSI Pressure Washer Step 1 Attach the high pressure hose to the gun. Use a wrench to tighten the fitting. Step 2 Insert the adjustable spray nozzle into the gun. Push and turn the adjustable nozzle clockwise onto the gun until hand tight to lock it in place. When the pieces are joined properly, you cannot separate the two components by pulling straight out on the adjustable nozzle. All attachments must be inserted into the gun for proper use.
1600 PSI Pressure Washer Step 3 Attach the high-pressure hose to the male fitting on the front of the pressure washer. Before attaching the high-pressure hose to the male fitting, remove the plastic cap, which is inserted onto the fitting before shipping. This plastic cap can be discarded once removed. Twist on tight to avoid leakage. Step 4 Attach the hose connector to pressure washer.
1600 PSI Pressure Washer OPERATING INSTRUCTIONS THIS UNIT IS INTENDED TO BE USED WITH COLD WATER ONLY! DO NOT USE HOT WATER IN THIS PRESSURE WASHER! Starting Up After connecting the pressure washer to your cold water supply, proceed as follows: - Make sure that the on/off switch is in the off position. Connect the garden hose with quick connect to the inlet fitting. Attach the hose to the gun as per assembly instruction step #1. Insert the adjustable spray nozzle into the gun as per assembly step #2.
1600 PSI Pressure Washer Automatic On / Off The pressure washer is equipped with an automatic on/off switch.The pressure washer will only run when the power switch is in the ON position and the trigger on the gun is squeezed. When you release the trigger to stop spraying water through the gun, the motor on the pressure washer will automatically shut off. Simply squeeze the trigger again to resume using the washer.
1600 PSI Pressure Washer Diagram 2 Diagram 1 Detergent Nozzle The detergent nozzle will allow you to apply many forms of liquid detergent onto the work surface.Detergent application happens at low pressure only. Fill the container with detergent only.Do not put any water into the container.The pressure washer will mix water and detergent automatically. When finished applying the detergent to the work surface, insert the adjustable spray nozzle, and remove the detergent by using the high pressure spray.
1600 PSI Pressure Washer ADJUSTING THE PRESSURE To adjust the pressure,proceed as follows: 1. Hold the shaft of the lance in one hand. 2. Turn the grey part of the nozzle clockwise (to “+” end) to obtain the high pressure. 3. Turn the grey part of the nozzle anticlockwise (to “-” end) to obtain the low pressure. Low Pressure Setting High Pressure Setting TOTAL STOP SYSTEM The pressure washer is fitted with a total stop system to protect the motor when in use.
1600 PSI Pressure Washer Step 3 Offloading the Front-gun, and install the detergent nozzle with the bottle. Back-gun Detergent nozzle Front-gun Detergent bottle Step 4 To apply the detergent cleanser to your working area, turn the pressure washer switch to the ON position. Pull the trigger to operate the unit. The pressure washer will mix the detergent with water. Do not allow the detergent to dry on the object that you are cleaning.
1600 PSI Pressure Washer CLEAN-UP AND STORAGE Shutting Down the Pressure Washer WHEN FINISHED USING THE PRESSURE WASHER,FOLLOW THESE STEPS TO SHUT DOWN THE UNIT: • • • • • • • • • • • Turn the pressure washer to the OFF position. Turn off the water supply. Before disconnecting high-pressure hose connection, point the gun in a safe direction and discharge the high-pressure water. Disconnect high-pressure hose from the pressure washer and gun. Disconnect garden hose from the pressure washer.
00 PSI Pressure Washer Winterizing and Long-Term Storage FOLLOW ALL OF THE ABOVE SHUT-DOWN PROCEDURES,ADDING THE FOLLOWING STEPS…. • After disconnecting the water supply, and before disconnecting the high-pressure hose, turn the pressure washer on for 2-3 seconds, until any remaining water in the pump exits. Turn unit off immediately.
1600 PSI Pressure Washer CLEANING TIPS WARNING: ALWAYS TEST THE SPRAY IN AN AREA FREE AND CLEAR OF PEOPLE AND OBJECTS BEFORE YOU SPRAYAT THE INTENDED CLEANING SURFACE. Wood and Vinyl Decks Rinse deck and surrounding area with fresh water. If using detergent, fill the detergent reservoir and apply to the area being cleaned at low pressure. For optimal results, reduce your work area to smaller sections and clean each section one at a time.
1600 PSI Pressure Washer Maintain a further distance from the cleaning area when using a direct spray. Wipe surface dry for a polished finish. Barbecue Grills, Power Equipment, and Garden Tools Rinse cleaning and surrounding area with fresh water. If using detergent, fill the detergent reservoir and apply to the area being cleaned at low pressure. Allow the detergent to rest on the surface for a few minutes, but do not let the detergent dry.
1600 PSI Pressure Washer TROUBLESHOOTING TIPS WHEN THE SWITCH IS IN THE “I” POSITION THE MACHINE WILL NOT START PROBABLE CAUSE SOLUTION Electrical socket is faulty Voltage is inadequate GFCI trips Power cord is not plugged in Check plug, socket, and fuses Check that the voltage is adequate Reset / Try another outlet Plug in power cord THE PUMP DOES NOT REACH ADEQUATE PRESSURE OR FLUCTUATES SOLUTION PROBABLE CAUSE Water Intake Filter is clogged Pump is drawing air Suction valves are clogged/worn Diame
1600PSI PRESSURE WASHER Limited Warranty All-Power America warrants to the original purchaser who uses the product in a consumer application (personal, residential or household usage) that all products covered under this warranty are free from defects in material and workmanship for one year from the date of purchase. All products covered by this limited warranty which are used in commercial applications (i.e.
1600PSI PRESSURE WASHER Limited Warranty THIS WARRANTY DOES NOT COVER: • Merchandise sold as reconditioned, used as rental equipment, or floor or display models.
1600PSI PRESSURE WASHER EXPLODED VIEW 21
1600PSI PRESSURE WASHER PARTS LISTING APA Part No. Description Part No. APW5005-01-MT Handle 1 APW5005-02-MT Screws(ST3.9X25) 2 APW5005-03-MT Baffle(left) 3 APW5005-04-MT Case(rear) 4 APW5005-05-MT Baffle(right) 5 APW5005-06-MT Hook 6 APW5005-07-MT Plug and Power Cable 7 APW5005-08-MT Wheels 8 APW5005-09-MT Motor and Pump 9 APW5005-10-MT Rubber Bands 10 APW5005-11-MT Switch Knob 11 APW5005-12-MT Case(front) 12 APW5005-13-MT Screws(ST2.