User Manual
14
Programmable Features 3.6L Gas
Programming Menu
The vehicle has to be running to turn o cruise control.
NOTE: To access the programming menu of the device, cruise control must be
turned o. Each feature adjustment requires a new programming session.
Six modes can be accessed through the programming menu. The
speedometer (MPH) gauge is used to display the modes and programming
inputs. The cruise control switches will be used to navigate the programming
menu.
Access the Programming Menu
Speed
Limiter
TPMS
Tire Size
Axle Ratio
DFM/AFM Disable
STEP 1 - The vehicle must be turned o.
STEP 2 - Without starting the vehicle, turn the key to the “ON/RUN” position.
STEP 3 - Adjust the vehicle’s screen cluster to the digital speedometer
STEP 4 - Hold the cancel cruise control button until the speedometer sweeps
to 140 (approx. 5 seconds).
STEP 5 - Use the +RES or –SET wheel to navigate to the desired
programming mode.
STEP 6 - Press the cancel cruise control button to select the mode.
STEP 7 -The speedometer gauge will sweep and then stop at the current
programmed condition. (The stock input will be displayed if not previously
adjusted.)
NOTE: During programming, the seatbelt warning light may activate.
10 - Speed Limiter (82-140 MPH)
20 - TPMS Adjustment (25-99 PSI)
30 - Tire Size Correction (Input stock then
modied sizes for front and rear tires)--up
to 50”
40 - Axle Ratio (Input stock then modied
axle ratio)
50 - Clear DTC’s
60 - DFM/AFM Disable
Clear DTC’s