User Manual

Pulsar LT Installation

STEP 1 - Before installation, disconnect the negative terminal of the battery to

avoid a Check Engine light after installation.

NOTE: The connector is

located on the driver side

next to the fuse box.

STEP 3 - Once the connector

is removed, install the Pulsar

harness onto the factory

connector. Pull up on the gray

lever until it stops, then slide the

red lock tab up to lock them in

place.

STEP 2 - On the upper most connector next to the driver side fuse box, slide the

red locking tab. Then, push the red lock and rotate the gray lever to release the

connector.

Battery Cover (STEP 4)