Operating instructions

www.pulsar.pl EN54-2A17LCD RED POWER

6.7. Indication of the enclosure opening - TAMPER.

The PSU is fitted with the microswitch tamper indicating enclosure opening.

The tamper cable is not connected to the terminal in the factory settings. In order to activate tamper,

remove the jumper from tamper terminal (Fig. 2 [12]) and plug in the tamper cable.

Each opening the enclosure will generate a failure signal at the PSU FLT and ALARM technical outputs

and will save the event in the internal memory of the PSU.

6.8. Increasing the number of outputs with optional EN54-LB4 or EN54-LB8 fuse

modules.

The PSU has two independently protected outputs for connecting the AUX1 and AUX2 receivers.

If the power supply unit is connected with more receivers, then it is recommended to secure each of them with

independent fuse. This solution will protect the power supply system, while the damage to only one receiver (short-

circuit on the line) could cause damage to other receivers connected to the same output.

The solution is provided by the optional fuse module EN54-LB4, 4-channel or EN54-LB8, 8-channel, while

its mounting location is provided within the housing (see Fig. 4). The figure below shows the connection between

the power supply, fuse module and receivers.

Fig.21. The connection of fuse module

When installing the fuse module in the PSU, power supply current consumption, used for the

calculation of standby time (see section 8.8), should be taken into account.

Depending on the version, fuse module allows to connect 4 or 8 receivers to the PSU. Output state is indicated by

green LEDs.

Blown fuse is indicated as follows:

- corresponding LED turns off: L1 for AUX1 etc.

- red LED on

- PSU technical output on (Hi-Z state)

- switching PSU relay output into voltage free status (contacts as shown in the Fig. 21).

In addition, blown fuse signal is transmitted to the input of collective failure EXTi (ALARM) and saved in the

internal memory of PSU.

The PSU’s relay output can also be used for remote control, including external optical indication.