User Instructions

www.pulsar.pl EN54C RED POWER plus

GENERAL SAFETY RULES

Before installation, read the instruction manual to avoid errors that

can damage the device and give you an electric shock.

 Before installation, cut off the voltage in the 230 V power-supply circuit.

 To switch power off, use an external switch, in which the distance between the

contacts of all poles in the disconnection state is not less than 3mm.

 The shock protection circuit shall be done with a particular care: the yellow and green

wire coat of the power cable should be connected to the terminal marked with

the grounding symbol on the PSU enclosure. Operation of the PSU without the

properly made and fully operational shock protection circuit is UNACCEPTABLE! It

can cause damage to the equipment or an electric shock.

 The device should be transported without batteries. This has a direct impact on the

safety of the user and the device.

 Installing and connecting the power supply must be carried out without batteries.

 When connecting batteries to the power supply, pay particular attention to the correct

polarity. If necessary, it is possible to permanently disconnect the battery from the

power supply systems by removing the F

BAT

fuse.

 The power supply is adapted to be connected to a power distribution network with an

effectively earthed neutral conductor.

 Ensure a free, convection air flow around the enclosure. Do not cover the ventilation

openings.