User Instructions

www.pulsar.pl INTE
10
5.2 Configuration of power supplies of PSBEN series with LED display.
The PSU is fitted with LED display, which enables setting the communication parameters of the serial port
from the LED panel. To enter the setup mode, simultaneously press the „<,>” rightmost and leftmost buttons on the
LED panel.
- simultaneously press the „<,>” rightmost and leftmost buttons
- The „tSt” parameter will be displayed
- press the right arrow „>”
- The „trS” parameter will be displayed
- press „OK”
- The information about the selected transmission speed will be displayed
- use the „<” or „>” buttons in order to set the transmission speed,
- confirm by pressing „OK.”
- The „trS” parameter will be displayed again
- press the right arrow „>”
- The „trP” parameter will be displayed
- press „OK”
- The information about the selected parity of the transmission will
be displayed
- use the „<” or „>” buttons in order to set the „8E1” parameter
- confirm by pressing „OK.”
- Simultaneously press the „<,>” rightmost and leftmost buttons
to complete the configuration procedure