User Instructions

www.pulsar.pl INTE
12
5.4 Configuration of power supplies of EN54 series with LED display
The PSU is fitted with LED display, which enables setting the communication parameters of the serial port
from the LED panel. To enter the setup mode, simultaneously press the „<,>” rightmost and leftmost buttons on the
LED panel.
- simultaneously press the „<,>” rightmost and leftmost buttons
- The „tSt” parameter will be displayed
- use the „<” or „>” buttons in order to display the „trS” parameter
- The „trS” parameter will be displayed again
- press „OK”
- The information about the transmission speed will be displayed
- use the „<” or „>” buttons in order to set the required
transmission speed,
- confirm by pressing „OK”
- The „trS” parameter will be displayed
- press the right arrow „>”
- The „trP” parameter will be displayed
- Press “OK”
- The information about the selected parity of the transmission
will be displayed
- use the „<” or „>” buttons in order to set the „8E1” parameter
- confirm by pressing „OK.”
- in order to return to the main menu, simultaneously press the „<,>”
rightmost and leftmost buttons