User Instructions

www.pulsar.pl INTE
3
Features:
 connection to the ETHERNET network via the RJ45 connector
 Permission of the Scientific and Research Centre for Fire Protection - National Research Institute for use
with power supplies of the EN54 series in fire alarm systems
 compliance with the IEEE 802.3 standard
 10/100Mbps transmission speed
 full-duplex or half-duplex operation (auto-negotiation)
 assigning a static or dynamic IP address (DHCP server)
 galvanic isolation between the Ethernet interface and the power supply
 configured with the free PowerConfig program
 power supply via the „SERIAL” socket
 cooperation with the freeware PowerSecurity
 optical indication
 warranty - 5 years from the production date
1. General description.
The ETHERNET network interface is a device used to connect power supplies of the PSBEN or EN54
series to a PC via the Ethernet connection. The PowerSecurity software enables remote monitoring of parameters
through a cyclical preview of the current status of the power supply, reading the event log and diagrams of currents
and voltages and performing remote battery test.
2. Components arrangement.
The figure below shows the distribution of the major components and connectors of ETHERNET interface.
Fig.1. The interface view.
Table 1. Description of the components.
Component
no.
Description
[1]
LED lights – optical indication:
PWR – supply voltage
TX – transmitting data
RX – receiving
[2]
RST button – resetting the interface settings
[3]
RJ45 socket
[4]
SERIAL socket for connection with the power supply
[5]
Green LED light – Ethernet connection indication
[6]
Yellow LED light – Operating status indication