Operation Manual

English

● Setting the seconds:

• With the second digits flashing, press button D in accordance with a time signal. The

second digits are reset to “00”.

• When the seconds count any number from “30” to “59” and button D is pressed, one

minute is added and the seconds are reset to “00”.

● The flashing digits except the seconds and 12-/24-hour indication move quickly if button

D is kept pressed.

● When setting the hour digits in the 12-hour indication, check that AM/PM is properly set.

Only the “PM” mark is displayed. For the AM setting, there is no indication. In the 24-

hour indication, “24” is displayed.

● If the watch is left untouched with the digits flashing, it will automatically return to the

TIME/CALENDAR mode in 1 to 2 minutes.

● Note on unusual display:

While setting the time/calendar, all the segments of the display will light up if both

buttons C and D are pressed at the same time. This is not a malfunction. Press any one

of the buttons to return to the TIME/CALENDAR mode, and then set the time/calendar

again.

[ANALOGUE TIME SETTING]

● When setting the minute hand, first advance it 4 to 5 minutes ahead of the desired time

and then turn it back to the exact minute.

STOPWATCH MODE

● Restart and stop of the stopwatch can be repeated by pressing button C.

● Even if the STOPWATCH mode is changed to another while the measurement is in

progress, it continues counting properly. After the stopwatch is used, however, be sure

to reset it as the battery energy is consumed enormously to shorten the battery life.