Owner's manual

21
USING DETERGENTS
ADJUSTING THE PRESSURE
To adjust the pressure,proceed as follows:
1. Hold the shaft of the lance in one hand.
2. Turn the grey part of the nozzle clockwise
(to “+” end) to obtain the high pressure.
3. Turn the grey part of the nozzle anticlockwise
(to “-” end) to obtain the low pressure.
AUTO STOP SYSTEM
The pressure washer is fitted with an automatic stop system to protect the motor
when in use.
When the trigger is released the motor will stop.
When the trigger is squeezed the motor will start up again.
Biodegradable detergents are specifically formulated to protect the environment and
your pressure washer. These Detergents will not clog the filter and will protect the
internal parts of the pressure washer for a longer life.
Step 1
Open the cover of the detergent bottle by twisting it off.
Step 2
Fill the detergent bottle with any approved liquid detergent.
Close the cover.
1600 PSI Pressure Washer
Low Pressure Setting
High Pressure Setting
Detergent nozzle
Detergent bottle
31
Step 3
Remove the Front-gun, and install the detergent nozzle with the bottle.
Step 4
To apply the detergent to your work area. Turn the pressure washer switch
to the ON position. Pull the trigger to operate the unit. The pressure washer will mix
the detergent with water. Do not allow the detergent to dry on the object that you are
cleaning.
WARNING: NEVER USE PRODUCTS WITH BLEACH OR CHLORINE
OR ANY OTHER CORROSIVE MATERIALS, INCLUDING LIQUIDS
CONTAINING SOLVENTS (I.E. GAS, OILS ETC), TRI-SODIUM
PHOSPHATE PRODUCTS, AMMONIA, OR ACID-BASED CLEANERS.
THESE CHEMIC
ALS WILL HARM THE UNIT AND CAUSE DAMAGE
TO THE SURFACE BEING CLEANED. ALWAYS READ THE LABEL.
1600 PSI Pressure Washer
Detergent bottle
Detergent nozzle
Back-gun
Front-gun