000 PSI Pressure Washer Table Of Contents Topic Page # Important Safety Tips, Precautions, Warnings, and Usage Instructions 2-5 Assembly Instructions 6-8 Operating Instructions 8-11 Detergents 11-13 Clean-up and Storage 13-15 Cleaning Tips 15-16 Technical Data 16 Troubleshooting Tips 17 Limited Warranty 18- 19 Parts 20- 26 1
2000 PSI Pressure Washer GROUND FAULT CIRCUIT INTERRUPTER (GFCI) This pressure washer is provided with a ground fault circuit interrupter (GFCI) built into the plug of the power supply cord. This device provides additional protection from the risk of electric shock. Should replacement of the plug or cord become necessary, use only identical replacement parts that include GFCI protection. This unit is equipped with a Ground Fault Circuit Interrupter (GFCI).
2000 PSI Pressure Washer IMPORTANT SAFETY PRECAUTIONS WARNING: When using this product, basic precautions should always be followed, including the following: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. Read all instructions before using the product. Save all safety instructions. Do not operate the pressure washer when fatigued or under the influence of alcohol or drugs. Risk of infection or injury – do not direct the high pressure water stream at any people or animals.
2000 PSI Pressure Washer 5. 6. 7. 8. 9. Read all instructions included with the mask so you are certain the mask will provide the necessary protection against inhaling harmful vapors. Before starting the pressure washer in cold weather, check all of the parts of the equipment and be sure that ice has not formed. Do not store the unit anywhere that the temperature will fall below 0°C (32° F).
2000 PSI Pressure Washer electrical rating not less than the rating of the product.Examine the extension cord before use. Do not use damaged extension cords! Do not pull on cord to disconnect from the receptacle. Always disconnect by pulling on plug. Keep the cord away from heat and sharp edges. Always disconnect the extension cord from the receptacle before disconnecting the product from the extension cord. WARNING – To reduce the risk of electrocution, keep all connections dry and off the ground.
2000 PSI Pressure Washer ASSEMBLY INSTRUCTIONS Unpacking The Carton After opening the carton, please remove all parts and check them against the following list of components that are included: A. High Pressure Washer B. Gun C. High Pressure Hose D. 4 IN 1 Lance Adjustable Nozzle E. Two-way Connector F. Water Intake Filter (Pre-Installed) G. Detergent Bottle H.
2000 PSI Pressure Washer Step 1 To attach the power washer storage hook to the back of the machine, fristly align the hole. Then using the 3 screws provide and a screwdrive (no supplied), screw the storage hook to the back of the power washer. Storage Hook Step 2 Take the hose lock to position A to unlock. Attach the high pressure hose to the gun. Then push the hose lock to postion B to lock the fitting. B B A A Step 3 Insert the adjustable spray nozzle into the gun.
2000 PSI Pressure Washer Step 4 Attach the hose connector to pressure washer. Before attaching the connector to the male fitting, remove the plastic cap, which is inserted onto the male fitting on the pressure washer before shipping. This plastic cap can be discarded once removed. After both components have been installed, attach the garden hose with connector screw on the pressure washer. Connect the garden hose to the waterspout.
2000 PSI Pressure Washer - Connect the high pressure hose to the high pressure outlet fitting as per assembly step 2 and step 4. Open the water supply valve completely. Before turning the unit on, press the gun trigger to bleed all the remaining air out of the pump and hose. Start the pressure washer by turning the on/off switch to the on position and squeeze the trigger. REMINDER: The motor does not run continuously, only when the trigger is squeezed.
2000 PSI Pressure Washer Gun Safety Lock This pressure washer is equipped with a gun trigger safety lock. When not using the pressure washer, use the safety lock to protect from accidentally engaging the high pressure spray. Adjustable Spray Nozzle The 4 IN 1 adjustable nozzle will allow you to use a variety of spray patterns from a full fan spray to other spray. When using the pressure washer to clean wood decks, siding, vehicles etc.
2000 PSI Pressure Washer FIGURE B FIGURE A Low Pressure Setting High Pressure Setting ADJUSTING THE PRESSURE Low Pressure Setting To adjust the pressure,proceed as follows: 1. Hold the shaft of the lance in one hand. 2. Turn the grey part of the nozzle clockwise to obtain the high pressure. 3. Turn the grey part of the nozzle anticlockwise to obtain the low pressure. High Pressure Setting AUTO STOP SYSTEM The pressure washer is fitted with an automatic stop system to protect the motor when in use.
2000 PSI Pressure Washer Step 1 Open the cover of the detergent reservoir by twisting it off. Step 2 Fill the detergent reservoir with any approved liguid detergent. Close the cover. Step 3 Turn the adjustable nozzle to end of “LOW PRESSURE SOAP”, put the pressure into low-pressure mode. Low Pressure Setting Step 4 To apply the detergent to your work area. Turn the pressure washer switch to the ON position. Pull the trigger to operate the unit. The pressure washer will mix the detergent with water.
2000 PSI Pressure Washer High Pressure Setting CLEAN-UP AND STORAGE Shutting Down the Pressure Washer WHEN FINISHED USING THE PRESSURE WASHER,FOLLOW THESE STEPS TO SHUT DOWN THE UNIT: • • • • • • • Turn the pressure washer to the OFF position. Turn off the water supply. Before disconnecting high-pressure hose connection, point the gun in a safe direction and discharge the high-pressure water. Disconnect high-pressure hose from the pressure washer and gun. Disconnect garden hose from the pressure washer.
2000 PSI Pressure Washer • • • • Drain the detergent reservoir and flush with running water. Wipe away any remaining water on all parts and fittings. Engage the gun safety lock. Store the pressure washer, parts, and accessories in an area with a temperature above 0°C (32°F). Winterizing and Long-Term Storage FOLLOW ALL OF THE ABOVE SHUT-DOWN PROCEDURES,ADDING THE FOLLOWING STEPS….
2000 PSI Pressure Washer Garden Hose Connection High Pressure Hose Connection CLEANING TIPS WARNING: ALWAYS TEST THE SPRAY IN AN AREA FREE AND CLEAR OF PEOPLE AND OBJECTS BEFORE YOU AIMING AT THE INTENDED CLEANING SURFACE. Wood and Vinyl Decks Rinse deck and surrounding area with fresh water. If using detergent, fill the detergent reservoir and apply to the area being cleaned at low pressure. For optimal results, reduce your work area to smaller sections and clean each section one at a time.
2000 PSI Pressure Washer Cars, Boats, and Motorcycles Rinse the area with fresh water. If using detergent, fill the detergent reservoir and apply to the area being cleaned at low pressure. To achieve the best results, clean one side at a time. Allow the detergent to remain on the surface for a few minutes, but do not let the detergent dry. Rinse at high pressure using the fan spray in a sweeping motion keeping the tip of the spray nozzle at least 8 inches from the cleaning surface.
2000 PSI Pressure Washer TROUBLESHOOTING TIPS WHEN THE SWITCH IS IN THE “I” POSITION THE MACHINE WILL NOT START PROBABLE CAUSE SOLUTION Electrical socket is faulty Voltage is inadequate GFCI trips Power cord is not plugged in Check plug, socket, and fuses Check that the voltage is adequate Reset / Try another outlet Plug in power cord THE PUMP DOES NOT REACH ADEQUATE PRESSURE OR FLUCTUATES PROBABLE CAUSE SOLUTION Water Intake Filter is clogged Pump is drawing air Suction valves are clogged/worn Diame
2000 PSI Pressure Washer LIMITED WARRANTY Pulsar Products, Inc. warrants to the original purchaser who uses the product in aconsumer application (personal, residential or household usage) that all products covered under this warranty are free from defects in material and workmanship for one year from the date of purchase. All products covered by this limited warranty which are used in commercial applications (i.e.
00 PSI Pressure Washer LIMITED WARRANTY (cont’d) THIS WARRANTY DOES NOT COVER: • Merchandise sold as reconditioned, used as rental equipment, or floor or display models.
2000 PSI Pressure Washer 2000 PSI Pressure Washer EXPLODER VIEW 20 21
2000 PSI Pressure Washer MPG Assy Parts No. Moto Assy PWE2000A-1 PWE2000A-2 PWE2000A-3 PWE2000A-4 Pump Pedestal Assy PWE2000A-5 PWE2000A-6 PWE2000A-7 PWE2000A-8 PWE2000A-9 PWE2000A-10 PWE2000A-11 PWE2000A-12 Thrust Bearing Assy PWE2000A-13 PWE2000A-14 PWE2000A-15 Pistion Body Assy PWE2000A-16 PWE2000A-17 PWE2000A-18 PWE2000A-19 PWE2000A-20 PWE2000A-21 Pilot Sheath Assy PWE2000A-22 PWE2000A-23 Pump Body Assy PWE2000A-24 PWE2000A-25 PWE2000A-26 PWE2000A-27 PWE2000A-28 One-Way Valve Assy DESCRIPTION QTY.
2000 PSI Pressure Washer MPG Assy Parts No.
2000 PSI Pressure Washer MPG Assy Parts No.
2000 PSI Pressure Washer Complete Machine Parts No.
2000 PSI Pressure Washer Complete Machine Parts No. PWE2000A-124 PWE2000A-125 PWE2000A-126 PWE2000A-127 PWE2000A-128 Cable Assy PWE2000A-129 PWE2000A-130 PWE2000A-131 PWE2000A-132 PWE2000A-133 PWE2000A-134 PWE2000A-135 PWE2000A-136 PWE2000A-134 PWE2000A-135 PWE2000A-136 Acc. PWE2000A-137 PWE2000A-138 PWE2000A-139 PWE2000A-140 PWE2000A-141 PWE2000A-142 PWE2000A-143 PWE2000A-144 PWE2000A-145 DESCRIPTION Cross Pan Self-Tapping Screw Cross Pan Self-Tapping Screw Handle ( Front ) Handle ( Back ) Iron Pipe QTY.
本页为封底,此处2行文字不要印刷!!! 右下角英文需要印刷!!! PWE2000A Reu 9-10-14