2000PSI Electric Pressure Washer Model# PWE2019 Register Your Product @: support@pulsar-products.com If you prefer to register by mail please send a self-addressed, stamped envelope to: Pulsar Products – Warranty Registration 5721 E.
000 PSI Pressure Washer Table Of Contents Topic Page # Important Safety Tips, Precautions, Warnings, and Usage Instructions 2-5 Assembly Instructions 6-8 Operating Instructions 8-11 Detergents 11-13 Clean-up and Storage 13-15 Cleaning Tips 15-16 Technical Data 16 Troubleshooting Tips 17 Limited Warranty 18- 19 Distributed By: Bluestem Brands 6250 Ridgewood Rd. St. Cloud, MN 56303 1-888-205-5864 (8 AM-5 PM CST) Manufactured By: Pulsar Products, Inc.
2000 PSI Pressure Washer GROUND FAULT CIRCUIT INTERRUPTER (GFCI) This pressure washer is provided with a ground fault circuit interrupter (GFCI) built into the plug of the power supply cord. This device provides additional protection from the risk of electric shock. Should replacement of the plug or cord become necessary, use only identical replacement parts that include GFCI protection. This unit is equipped with a Ground Fault Circuit Interrupter (GFCI).
2000 PSI Pressure Washer IMPORTANT SAFETY PRECAUTIONS WARNING: When using this product, basic precautions should always be followed, including the following: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. Read all instructions before using the product. Save all safety instructions. Do not operate the pressure washer when fatigued or under the influence of alcohol or drugs. Risk of infection or injury – do not direct the high pressure water stream at any people or animals.
2000 PSI Pressure Washer 5. 6. 7. 8. 9. Read all instructions included with the mask so you are certain the mask will provide the necessary protection against inhaling harmful vapors. Before starting the pressure washer in cold weather, check all of the parts of the equipment and be sure that ice has not formed. Do not store the unit anywhere that the temperature will fall below 0°C (32° F).
2000 PSI Pressure Washer electrical rating not less than the rating of the product.Examine the extension cord before use. Do not use damaged extension cords! Do not pull on cord to disconnect from the receptacle. Always disconnect by pulling on plug. Keep the cord away from heat and sharp edges. Always disconnect the extension cord from the receptacle before disconnecting the product from the extension cord. WARNING – To reduce the risk of electrocution, keep all connections dry and off the ground.
2000 PSI Pressure Washer ASSEMBLY INSTRUCTIONS Unpacking The Carton After opening the carton, please remove all parts and check them against the following list of components that are included: A. Pressure Washer B. Stainless Steel Gun C. Hose Reel with High Pressure Hose D. 4 High Pressure Nozzles 0°, 15°, 40° and Soap E. ON/OFF Switch F. Big Wheel For Easy Mobility G. GFCI Protected Power Cord H.
2000 PSI Pressure Washer Step 1 Align handle frame with the lower frame and insert tubes until you here a click. Make sure the handle portion of the pressure washer locks into place with the lower frame. Step 2 Secure the stainless steel wand to the pressure gun. Step 3 Insert the high pressure hose to the the gun and tighten to secure it.
2000 PSI Pressure Washer Step 4 Remove the plastic cap on the garden hose connector which is inserted onto the male fitting on the pressure washer before shipping. This plastic cap can be discarded once removed. Attach the garden hose with connector screw on the pressure washer. Connect the garden hose to the waterspout.
2000 PSI Pressure Washer - Connect the high pressure hose to the high pressure outlet fitting. - Open the water supply valve completely. Before turning the unit on, press the gun trigger to bleed all the remaining air out of the pump and hose. Start the pressure washer by turning the on/off switch to the on position and squeeze the trigger. REMIN DER: T h e motor does n ot run continu ously, only wh en t h e trig ge r is squ e e z ed.
2000 PSI Pressure Washer Gun Safety Lock This pressure washer is equipped with a gun trigger safety lock. When not using the pressure washer, use the safety lock to protect from accidentally engaging the high pressure spray. Adjustable Spray Nozzle Equipped with for spray nozzles thiswill allow you to use a variety of spray patterns from a full fan spray to other spray. When using the pressure washer to clean wood decks, siding, vehicles etc.
2000 PSI Pressure Washer AUTO STOP SYSTEM The pressure was her is fitted with an automatic stop system to protect the motor when in use. When the trigger is released the motor will stop. When the trigger is squeezed the motor will start up again. USING DETERGENTS The pressure washer will dispense detergent only at low pressure. Use the asoap spray nozzle to apply detergents. Biodegradable detergents are specifically formulated to protect the environment and your pressure washer.
2000 PSI Pressure Washer Step 1 Open the cover of the detergent reservoir by twisting it off. Step 2 Fill the detergent reservoir with any approved liguid detergent. Close the cover. Step 3 Attach the soap spray nozzle. Step 4 To apply the detergent to your work area. Turn the pressure washer switch to the ON position. Pull the trigger to operate the unit. The pressure washer will mix the detergent with water. Do not allow the detergent to dry on the object that you are cleaning.
2000 PSI Pressure Washer CLEAN-UP AND STORAGE Shutting Down the Pressure Washer WHEN FINISHED USING THE PRESSURE WASHER,FOLLOW THESE STEPS TO SHUT DOWN THE UNIT: • • • • • • • Turn the pressure washer to the OFF position. Turn off the water supply. Before disconnecting high-pressure hose connection, point the gun in a safe direction and discharge the high-pressure water. Disconnect high-pressure hose from the pressure washer and gun. Disconnect garden hose from the pressure washer.
2000 PSI Pressure Washer • • • • Drain the detergent reservoir and flush with running water. Wipe away any remaining water on all parts and fittings. Engage the gun safety lock. Store the pressure washer, parts, and accessories in an area with a temperature above 0°C (32°F). Winterizing and Long-Term Storage FOLLOW ALL OF THE ABOVE SHUT-DOWN PROCEDURES,ADDING THE FOLLOWING STEPS….
2000 PSI Pressure Washer CLEANING TIPS WARNING: ALWAYS TEST THE SPRAY IN AN AREA FREE AND CLEAR OF PEOPLE AND OBJECTS BEFORE YOU AIMING AT THE INTENDED CLEANING SURFACE. Wood and Vinyl Decks Rinse deck and surrounding area with fresh water. If using detergent, fill the detergent reservoir and apply to the area being cleaned at low pressure. For optimal results, reduce your work area to smaller sections and clean each section one at a time.
2000 PSI Pressure Washer Cars, Boats, and Motorcycles Rinse the area with fresh water. If using detergent, fill the detergent reservoir and apply to the area being cleaned at low pressure. To achieve the best results, clean one side at a time. Allow the detergent to remain on the surface for a few minutes, but do not let the detergent dry. Rinse at high pressure using the fan spray in a sweeping motion keeping the tip of the spray nozzle at least 8 inches from the cleaning surface.
2000 PSI Pressure Washer TROUBLESHOOTING TIPS WHEN THE SWITCH IS IN THE “I” POSITION THE MACHINE WILL NOT START PROBABLE CAUSE SOLUTION Electrical socket is faulty Voltage is inadequate GFCI trips Power cord is not plugged in Check plug, socket, and fuses Check that the voltage is adequate Reset / Try another outlet Plug in power cord THE PUMP DOES NOT REACH ADEQUATE PRESSURE OR FLUCTUATES PROBABLE CAUSE SOLUTION Water Intake Filter is clogged Pump is drawing air Suction valves are clogged/worn Diame
2000 PSI Pressure Washer LIMITED WARRANTY Pulsar Products, Inc. warrants to the original purchaser who uses the product in aconsumer application (personal, residential or household usage) that all products covered under this warranty are free from defects in material and workmanship for one year from the date of purchase. All products covered by this limited warranty which are used in commercial applications (i.e.
00 PSI Pressure Washer LIMITED WARRANTY (cont’d) THIS WARRANTY DOES NOT COVER: • Merchandise sold as reconditioned, used as rental equipment, or floor or display models.
MUST HAVE A BACK COVER！ DO NOT PRINT THE WORDS HERE!
