Owner`s manual
14
Owner’s Manual
Trouble Shooting
• Engine wil not start or stops while operating.
  Low-oil shutdown:      Fill engine with oil
  Engine switch not in “ON” position:  Turn switch “ON”S
  Pressure built up in hose:    Squeeze trigger while starting
• Engine is overloaded
 Nozzle partially blocked  Clean Nozzle
  Excessive pressure      Shorten the spring coil on the reflux valve
• Pressure increases when gun is locked 
  Bypass valve blocking      Clean the bypass valve
• Engine is running but pump won’t build maximum pressure or has irregular pressure 
 Faucet closed  Open faucet
  Unit has been stored in freezing temp.  Thaw out unit completely
  Inadequate water supply    Provide a minimum of 4 GPM at 20 PSI
  Water inlet screen clogged    Clean screen
  Kink in garden hose      Straighten garden hose
  Wand nozzle worn or damaged  Replace nozzle
  Air in pump        Run with gun open & wand removed
 until steady stream of water is released
  Adjustable pressure knob not set  Set to maximum position
  to maximum position
  Suction or discharge valves clogged  Clean the suction or discharge valves
  or worn out
  Bypass valve not operating effectively  Clean the bypass valve
• No intake of chemicals
  Injection tube not securely inserted  Push firmly into injector
 into unit
  Tube cracked or split      Replace tube
  Wrong nozzle        Switch to low pressure nozzle
  Injector turned off      Turn collar counter
• Trigger will not move
  Gun safety lock engaged    Release safety lock
15
Owner’s Manual
Trouble Shooting
• Water in crankcase
  High humidity      Change oil more frequently
  Worn seals      Change the oil seals
• Noisy operation
 Worn bearings  Change the bearings
  Air mixed with water    Check inlet lines for restrictions
 and / or proper sizing
• Rough / pulsating, operating with pressure drop
  Inlet restriction      Check system for stoppages, air leaks,
 correctly sized inlet plumbing to pump
  Unloader      Check unloader for proper operation
  Air mix in water     Check inlet lines for restrictions and or
 proper sizing
• High crankcase temperatures
  Wrong grade of oil    Use recommended oil
  Improper amount of   
  oil in crankcase     Adjust oil to proper amount 










