RCB48V v.1.0 Battery controller 48VDC/5A/4x17Ah for RACK 19" cabinets EN Edition: 1 from 09.02.
www.pulsar.pl RACK POWER RCB48V The battery controller features: Microprocessor-based automation system Automatic battery test every 5min.
www.pulsar.pl RACK POWER RCB48V 1. Technical description. 1.1. General description. The RCB48V battery controller is designed for monitoring the status of the 4x17Ah/12V (SLA) battery pack based on the measurements of resistance, continuity of the battery circuit, voltage, and the charge level. It is also protected against reverse connection and short circuit in the charging circuit.
www.pulsar.pl RACK POWER RCB48V Fig.2. General view. 1.4. Technical parameters. - Electrical parameters (Table 2) - Mechanical parameters (Table 3) - Operation safety (Table 4) - Operation parameters (Table 5) Electrical parameters (Table 2).
www.pulsar.pl RACK POWER RCB48V Mechanical parameters (Table 3).
www.pulsar.pl RACK POWER RCB48V 2.2. Installation procedure. 1. Mount the battery controller inside a RACK 19"cabinet as shown in the figure below: Fig. 3 Mounting the controller in a RACK cabinet. Fig. 4 The battery mounting method. Is possible to adjust the mounting brackets so that the front panel extends beyond the RACK rails. To do this, remove the cover and adjust the handles that are inside the cabinet. 2. Remove screws securing the front panel.
www.pulsar.pl RACK POWER RCB48V 3.2. Technical output. The controller is fitted with the ALARM technical output of collective failure. The collective failure can be triggered by the events presented in Table 6. Fig. 6. The electrical diagram of the ALARM output of collective failure. CAUTION! In Fig. 6 the set of contacts shows a potential-free status of the relay which corresponds to a failure. 3.3. Acoustic indication.
www.pulsar.pl RACK POWER RCB48V WEEE LABEL Waste electrical and electronic equipment must not be disposed of with normal household waste. According to the European Union WEEE Directive, waste electrical and electronic equipment should be disposed of separately from normal household waste. The power supply unit is adapted for a sealed lead-acid battery (SLA). After the operation period it must not be disposed of but recycled according to the applicable law.
