CAL.
SCREW DOWN CROWN DISPLAY AND CROWN/BUTTONS [for models with screw down crown] Unlocking the crown 1 Turn Crown counterclockwise until you no longer feel the threads turning. B b CROWN * The shape of the digital display differs depending on the calibre. A Locking the crown C PM 2 Crown can be pulled out. 1 Push Crown back in to normal position. English English a Digital display a: Normal position b: Extended position 2 Turn Crown clockwise while pressing it lightly until tight.
TIME/CALENDAR SETTING DIGITAL TIME SETTING ● Before setting the analogue time, be sure to set the digital time. CALENDAR SETTING Select the digits to be adjusted. C Set the flashing digits. ▲ Month Date Day A or B Return to CALENDAR mode. ➾ 4 B Select the digits to be adjusted. (Press for 2 to 3 seconds.) A C C Set the flashing digits. Hour Minutes Seconds A or B Return to TIME mode.
ANALOGUE TIME SETTING ALARM ● Before setting the analogue time, be sure to set the digital time. (See the previous section) Second hand 2 Turn to set the hour and minute hands. Select the digits to be adjusted. C Set the flashing digits. C A Minutes ➠ ALARM mode mark A or B Return to ALARM mode. Selection of the digits Hour ➾ Minutes ➾ ALARM mode ➾ PM Hour 6 B ▲ 3 Push back in to normal position when the second digits count “00” in the digital time display. Press to show ALARM mode.
ALARM ENGAGEMENT/DISENGAGEMENT C Alarm mark * At the designated time, the alarm rings for 20 seconds. To stop it manually, press any of the buttons. C Alarm engaged ● The stopwatch measures up to 60 minutes in 1/100 second increments.
NOTES ON OPERATING THE WATCH Measurement of two competitors RESET ILLUMINATING LIGHT C PM C 10 FINISH TIME OF 2ND COMPETITOR B Press and hold in TIME or CALENDAR mode. * The light illuminates the digital display for easy viewing in the dark. TIME/CALENDAR SETTING [CALENDAR SETTING] ● The calendar automatically adjusts for odd and even months except February of leap years. ● The flashing digits move quickly if button C is kept pressed.
● When the crown is pulled out or pushed in for time setting, the minute hand may move slightly. However, this is not a malfunction. BATTERY CHANGE [ALARM TIME SETTING] ● When the time function is displayed in the 24-hour indication, the alarm will also be displayed in the 24-hour indication. ● The flashing digits move quickly if button C is kept pressed. ● When setting the hour digits in the 12-hour indication, check that AM/PM is properly set. Only the “PM” mark is displayed.
digital display will light up, a beep will sound twice and then “January 1st, Sunday” will be displayed in the digital display. * Before using the watch, set the time/calendar and alarm. CAUTION ● The battery is not rechargeable. Never attempt to recharge it, as this may cause battery leakage or damage to the battery.
NOTE: Pressure in bar is a test pressure and should not be considered as corresponding to actual diving depth since swimming movement tends to increase the pressure at a given depth. Care should also be taken on diving into water. TEMPERATURES Your watch works with stable accuracy within a temperature range of 5° C and 35° C (41° -5°C F and 95° F). Temperatures over 50° C (122° F) or below –5° C (+23° F) may +50°C 16 cause a slight time loss or gain or battery leakage or shorten the battery life.
English PERIODIC CHECK 18 It is recommended that the watch be 2-3 checked once every Years 2 to 3 years. Have your watch checked by an AUTHORIZED PULSAR DEALER or SERVICE CENTER to ensure that the case, crown, buttons, gasket and crystal seal remain intact. STATIC ELECTRICITY The IC (Integrated Circuit) used in your watch will be affected by static electricity which may disturb the display. Keep the watch away from close contact with objects such as TV screens which emit strong static electricity.
