Operation Manual

English
English
1312
BATTERY CHANGE
Battery life : Approx. 3 years
Battery : SEIKO SR927W
● If the alarm is used more than once a day, the stopwatch more than once a day, and/
or the illuminating light for more than one second a day, the battery life may be less
than the specified period.
● As the battery is inserted at the factory to check the function and performance of
the watch, its actual life once in your possession may be less than the specified
period.
● When the battery expires, be sure to replace it as soon as possible to prevent any
malfunction.
● We recommend that you contact an AUTHORIZED PULSAR DEALER for battery
replacement.
3
Years
● Necessary procedure after battery change
After the battery is replaced with a new one, or in case an abnormal display (broken
digits, etc.) appears in the digital display, follow the procedure below to reset the IC.
Press buttons A, B and C at the same time. All the segments of the
● When the crown is pulled out or pushed in for time setting, the minute hand may move
slightly. However, this is not a malfunction.
STOPWATCH
● With each press of button C, the light illuminates the digital display with a beep.
● After measuring 60 minutes, the stopwatch will start counting again from “00'00"oo”
as many times as necessary until it is stopped.
● Restart and stop of the stopwatch can be repeated by pressing button C.
● Measurement and release of split time can be repeated by pressing button B.
● When measuring a long period of time, press button A to return the STOPWATCH mode
to the CALENDAR or TIME mode after the stopwatch starts. This will prevent any
possible malfunction.
ALARM
[ALARM TIME SETTING]
●
When the time function is displayed in the 24-hour indication, the alarm will also be
displayed in the 24-hour indication.
● The flashing digits move quickly if button C is kept pressed.
● When setting the hour digits in the 12-hour indication, check that AM/PM is properly set.
Only the “PM” mark is displayed. For the AM setting, there is no indication.
● If the watch is left untouched with the digits flashing, it will automatically return to the
ALARM mode in 1 to 2 minutes.
● Alarm test: The alarm can be tested by keeping buttons B and C pressed in the
CALENDAR or TIME mode.