Operation Manual

17
● If the watch is left untouched with the digits flashing, it will automatically return to the
TIME/CALENDAR mode in 2 to 3 minutes.
● Note on unusual display:
While setting the time/calendar, all the segments of the display will light up if both
buttons A and B are pressed at the same time. This is not a malfunction. Press any one
of the buttons to return to the TIME/CALENDAR mode, and then set the time/calendar
again.
[ANALOGUE TIME SETTING]
● When setting the minute hand, first advance it 4 to 5 minutes ahead of the desired time
and then turn it back to the exact minute.
● When the crown is pulled out or pushed in for time setting, the minute hand may move
slightly. However, this is not a malfunction.
[TURNING ON/OFF OF HOURLY TIME SIGNAL AND BUTTON OPERATION
CONFIRMATION SOUND]
● If the hourly time signal coincides with the timer warning sound, the lap time signal or
the alarm, the hourly time signal will not ring.
STOPWATCH MODE
● After measuring 100 hours, the stopwatch will automatically be reset to “00”.
● Restart and stop of the stopwatch can be repeated by pressing button A.
● Lap time measurement can be repeated by pressing button B.
● Lap time measured remains displayed for 5 to 6 seconds. Then, the display automatically