Operation Manual

English
English
1514
* Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the
crown is pushed in completely.
Do not operate the crown when the watch is wet or in water. If used in sea water,
rinse the watch in fresh water and dry it completely.
* When taking a shower with the water resistance 5 bar watch, or taking a bath with
the water resistance 10, 15 or 20 bar watch, be sure to observe the following:
Do not operate the crown when the watch is wet.
If the watch is left in warm water, a slight time loss or gain may be caused.
This condition, however, will be corrected when the watch returns to normal
temperature.
NOTE:
Pressure in bar is a test pressure and should not be considered as
corresponding to actual diving depth since swimming movement tends
to increase the pressure at a given depth. Care should also be taken on
diving into water.
TEMPERATURES
5
5
50° C (122° F) may cause battery
leakage or shorten the battery life.
Your watch works with
stable accuracy within a
temperature range of 5° C
and 35° C (41° F and 95° F).
Temperatures over
Do not leave your watch in very low
temperatures below –5° C (+23° F)
for a long time since the cold may
cause a slight time loss or gain.
However, the above conditions will
be corrected when the watch returns
to normal temperature.
MAGNETISM
Your watch will be
adversely affected by
strong magnetism. Keep
it away from close contact
with magnetic objects.
Be careful not to expose
the watch to solvents,
mercury, cosmetic spray,
detergents, adhesives
or paints. Otherwise,
CHEMICALS
the case, bracelet, etc. may
become discolored, deteriorated or
damaged.
Light activities will not
affect your watch, but be
careful not to drop your
watch or hit it against
hard surfaces, as this
SHOCKS & VIBRATION
may cause damage.
To prevent possible rusting of
the case and bracelet caused by
dust, moisture and perspiration,
wipe them periodically with a
soft dry cloth.
CARE OF CASE AND BRACELET
It is recommended that the
watch be checked once
every 2 to 3 years. Have
your watch checked by an
AUTHORIZED PULSAR
PERIODIC CHECK
DEALER or SER VICE CENTER to
ensure that the case, crown, buttons,
gasket and crystal seal remain intact.
PRECAUTION REGARDING
CASE BACK PROTECTIVE FILM
If your watch has a
protective film and/or a
sticker on the case back,
be sure to peel them off
before using your watch.
NPWA64_E.indd 14-15 13/01/25 13:53