CAL.
SCREW DOWN CROWN DISPLAY AND CROWN/BUTTONS [for models with screw down crown] CHRONOGRAPH 1/10-second hand Hour hand Minute hand 2 Crown can be pulled out. a b c CHRONOGRAPH minute hand CROWN Date B Second hand 1 Turn Crown counterclockwise until you no longer feel the threads turning. Locking the crown 1 Push Crown back in to normal position. English English A Unlocking the crown 2 Turn Crown clockwise while pressing it lightly until tight.
ADJUSTING CHRONOGRAPH HAND POSITION TIME/CALENDAR SETTING l Before setting the time, be sure to check that the CHRONOGRAPH hands are in “0” position when the chronograph is reset. (For resetting the chronograph, see "CHRONOGRAPH" on page 6) 2 1 CROWN s A A s B 4 CROWN s B CROWN 4 Pull out to second click. Press repeatedly to reset CHRONOGRAPH 1/10second hand to "0" position. Press repeatedly to reset CHRONOGRAPH second and minute hands to "0" position. Push back in to normal position.
CHRONOGRAPH TACHYMETER [for models with tachymeter scale on the dial] ☆ A Start / Stop / Restart 6 1 Use the chronograph to determine how many seconds it takes to go 1 km or 1 mile. s B Reset/ Split/Split release Ex.: 15 minutes and 10.6 seconds ☆ Ex. 1 Tachymeter scale: “90” CHRONOGRAPH minute hand CHRONOGRAPH second hand To measure the hourly average speed of a vehicle After the measurement exceeds 1 minute, the CHRONOGRAPH 1/10-second hand stays at “0” position.
tachymeter scale: “90” (tachymeter scale figure) x 2 (km or mile) = 180 km/h or mph “90” (tachymeter scale figure) x 0.5 (km or mile) = 45 km/h or mph To measure the hourly rate of operation 1 Use the chronograph to measure the time required to complete 1 job.
BATTERY CHANGE l While the crown is at the second click, do not press the buttons. Otherwise, the CHRONOGRAPH hands will move. To reset them to “0” position, see “ADJUSTING CHRONOGRAPH HAND POSITION” on page 4. l While the chronograph is counting, do not pull out the crown to set the time. Otherwise,the chronograph operation cannot be made. l The CHRONOGRAPH 1/10-second scale and hand differ in design and shape depending on the models.
l Necessary procedure after battery change After the battery is replaced with a new one, or in case any of the hands should move improperly, follow the procedure below to reset the hands to the “0” position. CROWN A s A and B s B s CROWN s English s * The CHRONOGRAPH second hand turns half a circle counterclock -wise and then returns where it was. The CHRONOGRAPH 1/10-second hand turns a full circle clockwise and stops. ** The hands move quickly if the respective buttons are kept pressed.
TO PRESERVE THE QUALITY OF YOUR WATCH WATER RESISTANCE English l Non-water resistant If “WATER RESISTANT” is not inscribed on the case back, your watch is not water resistant, and care should be taken not to get it wet as water may damage the movement. If the watch becomes wet, we suggest that you l Water resistance (10 bar/15 bar/20 bar)* have it checked by an AUTHORIZED PULSAR If “WATER RESISTANT 10 BAR”, DEALER or SERVICE CENTER.
CARE OF CASE AND BRACELET To prevent possible rusting of the case and bracelet caused by dust, moisture and perspiration, wipe them periodically with a soft dry cloth. English SHOCKS & VIBRATION 16 MAGNETISM Your watch will be adversely affected by strong magnetism. Keep it away from close contact with magnetic objects. PERIODIC CHECK It is recommended that the watch be checked once Light activities will not affect every 2 to 3 years.
