Operation Manual

is displayed. For the AM setting, there is no indication.

● As button “A” is pressed to return to the TIME display, the second digits are

automatically reset to “00” and start counting immediately. (See “● Setting the

seconds” explained above)

● If the watch is left untouched with the digits flashing, it will automatically return to the

TIME/CALENDAR mode in 1 to 2 minutes.

● Note on unusual display:

While setting the time/calendar, all the segments of the

display will light up if both buttons C and D are pressed at the

same time. This is not a malfunction. Press button A, C or

D to return to the TIME/CALENDAR mode, and then set the

time/calendar again.

SINGLE-TIME ALARM MODE

[SINGLE-TIME ALARM SETTING]

● When button C or D is pressed to set the single-time alarm, the single-time alarm mark

“1-AL” flashes for 2 to 3 seconds.

● With each press of button C or D, one minute is advanced or moved back, respectively.

The digits move quickly if the respective buttons are kept pressed.

● While the digits are advanced or moved back quickly by keeping button “C” or “D”

pressed, respectively, they start moving in 15-minute increments once they reach “00”,

“15”, “30” or “45”. Release the buttons as the digits nearest to the minutes you wish

to set are shown, and set them in 1-minute increments by pressing button “C” or “D”

repeatedly.