Operation Manual

42
Cal. W671Cal. W626
● Note on unusual display:
While setting the time/calendar, all the segments of the display will light up if both
buttons C and D are pressed at the same time. This is not a malfunction. Press any one
of the buttons to return to the TIME/CALENDAR mode, and then set the time/calendar
again.
STOPWATCH MODE
● Notes for Cal. W671:
1) Lap time measured and lap number remain displayed for 10 seconds, and then, the
current time appears in the upper row of the display.
2) The lap number counts up to “99”. After that, it is displayed in 2 digits such as “00”
for 100, “01” for 101, and so on.
3) The first 8 lap times are automatically stored in memory.
4) Even if the digits are reset to “00” in the stopwatch measurement, stored data is
not erased and can be recalled unless a new measurement is started.
5) When the button operation confirmation sound is turned on, a beep sounds every
minute to signal the lapse of time.
● Even if the STOPWATCH mode is changed to another while the measurement is in
progress, it continues counting properly and the flashing STOPWATCH mode mark
indicates that the stopwatch is in use. After the stopwatch is used, however, be sure
to reset it as the battery energy is consumed enormously to shorten the battery life.