Operation Manual

28 29
English
English
l
Necessary procedure after battery change
After the battery is replaced with a new one or if an abnormal display (broken digits,
etc.) appears, follow the procedure below to reset the IC.
Press and hold buttons A, B, C and D at the same time for 2 to 3 seconds. The display
will become blank. When the buttons are released, time/calendar display will appear
and “THU 12:00’00” 09 1-1” will be displayed.
l
Before using the watch, set the time/calendar and alarm.
WARNING
l
Do not remove the battery from the watch.
l
If it is necessary to take out the battery, keep it out of the reach of children.
If a child swallows it, consult a doctor immediately.
l
Never short-circuit, tamper with or heat the battery, and never expose it to
re. The battery may burst, become very hot or catch re.
CAUTION
l
The battery is not rechargeable. Never attempt to recharge it, as this may
cause battery leakage or damage to the battery.
TO PRESERVE THE QUALITY OF YOUR WATCH
WATER RESISTANCE
l
Non-water resistant
l
Water resistance (5 bar)*
If “WATER RESISTANT 5 BAR” is
inscribed on the case back, your
watch is designed and manu-
factured to withstand up to 5 bar
5 bar WR
and is suitable for swimming, yachting and taking
a shower.
If “WATER RESISTANT 10 BAR”,
“WATER RESISTANT 15 BAR” or
“WATER RESISTANT 20 BAR” is
inscribed on the case back, your
10/15/20
bar WR
l
Water resistance (10 bar/15 bar/20 bar)*
watch is designed and manufactured to withstand
up to 10 bar/15 bar/20 bar and is suitable for taking
a bath, shallow diving, but not for scuba diving.
We recommend that you wear a PULSAR Diver’s
watch for scuba diving.
If “WATER RESISTANT” is not
inscribed on the case back, your
watch is not water resistant, and
care should be taken not to get
If “WATER RESISTANT” is inscribed
on the case back, your watch is
designed and manufactured to
withstand up to 3 bar, such as acci-
l
Water resistance (3 bar)
dental contact with splashes of water or rain, but it
is not designed for swimming or diving.
it wet as water may damage the movement. If
the watch becomes wet, we suggest that you
have it checked by an AUTHORIZED PULSAR
DEALER or SERVICE CENTER.
3 bar WR